Mark April 04, 2011 for Model Number LGR7648KQ1 Okay tested flame sensor and I have continuity across terminals...what else can I check?
1 Answer Hello Mark. Did you test all the thermal cut-offs and the high limit thermostat? All of these should read closed for continuity. Hope this helps. Read More...
Mark April 04, 2011 for Model Number LGR7648KQ1 Dryer runs but no heat. Changed thermal fuse on rear, ignitor and coils. The ignitor will glow for a few seconds but burner doesn't come on. what else could be the problem?
1 Answer Hello Mark. Test the flame sensor WP338906 and see if it is good. It should read closed for continuity. Hope this helps. Read More...
Marvin March 05, 2011 My dryer works but only cool air theres no heat I think it is the coils but not sure what you think it is thanks
1 Answer We're really going to need a little more information before we can give you a good answer. Do you have your model #? Do you see the ignitor glowing, if it is a gas dryer? If the ignitor does glow, do you see the flame come on for a short period of time, or just fade away after a short time? Read More...
Kevin March 03, 2011 The dryer works with heat after replaced the ignitor and coils. No heat after about 7 minutes. Is there any parts no good and has to be replaced?
1 Answer Hello Kevin, You might have a cycling thermostat problem. If the thermostat is closed to start with and opens at 155F, then doesn't close back at 130F, the flame will not light again until it closes. WP3387134 Hope this helps. Read More...
Guest February 26, 2011 How would you know if your problem with the entire Burner assembly or just the ingnitor?
1 Answer If the ignitor is glowing, but will not light, you could have a weak ignitor. If it lights for a few seconds, then shuts off, you have bad coils. The ignitor should glow, if it is not broken. You will also need to test all your thermal fuses. Hope this helps. Read More...