Jaymare March 10, 2013 for Model Number PAV1000AWW When starting the washer on hot I get a loud vibration. Moving the control to warm reduces the vibration by about 50%. On cold settings it works fine. Thank you for your help.
1 Answer Jaymare, You will want to pull the water line off the hot side and check to make sure that the screen on the water valve is not clogged up. If it is then clean it out and retry to see if it is still making the noise. If it does then you will need a new water valve. Read More...
Randy February 19, 2013 for Model Number pav3360aww When in warm wash/cold rinse I get no warm water only cold. But when I select hot I get hot. Does the water valve mix the hot/cold/warm rinse or is it the select buttons function?
1 Answer Helo Randy. It sounds like the temp switch 21001226 is bad and will need to be replaced on the unit. Read More...
Mike M July 18, 2012 for Model Number pav2300aww I just ordered a water valve kit, part #35-2374N. In removing the old unit, I noted four wires, two red and two white. Where are they reinstalled on the new unit? Are you able to diagram using the display unit? Thank you.
1 Answer Hello Mike. White and pink goes to the hot solenoid and white and purple goes to the cold solenoid on the valve 35-2374N. Read More...
Dean June 29, 2011 for Model Number pav1000aww I have a Maytag washer that is getting no water, (hot or cold) everything else works. I have already changed the water fill valve with no luck, would changing the water level switch be the next step? Thanks Dean
1 Answer Hello Dean. If the machine starts agitating, without water in it, then the pressure switch WP21001554 will need to be replaced. Hope this helps. Read More...
Dean June 28, 2011 for Model Number pav1000aww I have a Maytag Performa washer. Everything works, but there is no water going in the machine ( hot or cold ). Is it safe to assume that it is the Fill Solenoid valve? I do have water to the machine.
1 Answer Hello Dean. You will need to test and see if there is power going to the water valve when turned on. If so, you will need to replace the water valve 35-2374N. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Marek K. April 18, 2011 for Model Number Magic ChefMdel W225LV SN 16798579UU My washer doesn`t take cold water , so it stops on rinse cycle . What might be wrong. Thanx in advance
1 Answer Hello Marek. Check and make sure the screens are not clogged on the water valve and hoses. If they are clear, you will need to replace the water valve. Hope this helps. Read More...
Kevin March 15, 2011 for Model Number pav3300 I have a maytag pav3300. The waterfill cycle will not stop filling and when I move to agitate, it will not agitate.
1 Answer Hello Kevin. It sounds like the pressure switch is bad. What are the first 5 numbers of the serial number? We will look up the part for you. Thanks. Read More...
1 Answer In most cases the hot is located on the left side and cold is on the right side once the valve is installed. Hope this helps! Read More...