Parts for Frigidaire CRA074AT714: 03 - Recommended Spare Parts

This air filter features a durable plastic frame and screens airborne particles from intake air to help protect internal components. Replacing a cracked or heavily clogged filter helps maintain proper airflow and keep the appliance running efficiently. What it does

• Captures dust and lint from incoming air to reduce buildup inside the unit
• Helps maintain airflow and overall system efficiency
• Replaces a missing, damaged, or saturated filter
• Common symptoms: weak airflow, longer run times, visible dirt buildup or damage to the filter

• 1 air filter with plastic frame

• Disconnect power to the appliance before servicing
• Open the front grille or filter access panel per your owner's manual
• Slide out the old filter and insert the new filter in the same orientation
• Ensure the filter is fully seated; do not operate the unit without a filter

This electronic control is the user interface and control board that manages oven functions, timers and temperature regulation to restore responsive controls and proper cooking cycles. Fits as the direct replacement control assembly. What it does:

• Replaces a faulty oven control board to restore display, keypad and timed functions.
• Manages temperature setpoints, bake/broil cycles and timed cooking operations.
• Commonly used when the display is blank, buttons are unresponsive, or oven fails to heat properly.
• Interfaces with sensors, switches and relays to coordinate heating elements and fans.

• Disconnect power to the appliance before servicing to avoid shock risk.
• Handle the board by its edges; avoid touching components and connectors to prevent ESD damage.
• Verify connector orientation and secure all fasteners; ensure wiring harnesses are fully seated.

Color: gray. Measures about 2 inches wide by 3-1/2 inches deep.

This thermistor is the refrigerator temperature sensor that helps the control board monitor and regulate cooling. Replacing a failed thermistor restores accurate temperature readings for more consistent fridge and freezer performance. What it does:

• Senses internal air temperature and sends that information to the control board
• Helps the defrost and compressor cycles run at the correct times
• Commonly linked to symptoms like inconsistent temperatures, error codes, or a unit that runs constantly
• Does not control cooling directly but provides the temperature feedback the system needs

• Always disconnect power to the appliance before beginning service
• Typically located in the fresh food or freezer compartment near the evaporator
• Handle the sensor and wiring gently; avoid pulling on the wires or bending the probe sharply
• If troubleshooting, verify wiring and sensor resistance per the manufacturer's service instructions before replacement

This overload protector helps prevent compressor overheating by interrupting power when the motor draws excessive current. It's a small, replaceable safety device that helps restore reliable compressor start behavior when failed. What it does:

• Protects the compressor motor from thermal overload and excessive current draw
• Stops the compressor from running if it overheats or is at risk of damage
• Commonly used when a fridge won't start, the compressor hums but won't run, or the compressor cycles erratically
• Works as part of the compressor start/protection assembly alongside relays and the compressor

• Disconnect power to the appliance before inspecting or replacing the overload protector
• Verify terminals and orientation match the original part; replace only with the same style part number
• Handle and install carefully to avoid bending terminals or damaging the compressor connection

Note: Due to a factory change, the replacement accordion does not include the frames.

Mounting hardware, screws