Parts for Kenmore 253.77080512 (25377080512, 253 77080512): Recommended Spare Parts

Replace your room air conditioner's cracked, dented, or warped front panel assembly. Restores appearance, supports controls, and protects components.

Replace your refrigerator water filter every 6 months to maintain clean, fresh-tasting water and ice. Reduces chlorine and traps sediment. Verify fit with your model.

Control panel for room air conditioner. Mounts on the front of the unit. Replace if cracked, broken, or cosmetically damaged. Essential for maintaining appearance.

Fix a unit that beeps and shuts off after 3 seconds, or temperature settings that increase by themselves. This control board replacement takes 30-45 minutes.

Replacement remote control for room air conditioners. Needed when original remote is lost, damaged, or has non-responsive buttons. Restores full control.

If your room air conditioner won't start or runs weakly, the capacitor may have failed. This part stores electrical charge to start the compressor.

Fix an air conditioner that won't start or runs but doesn't cool with this capacitor. Common failure part that causes the compressor not to run properly.

Air conditioner not responding to controls or won't turn on? This electronic control board manages all functions. Moderate difficulty repair, 30-45 minutes.

Fix inconsistent cooling in your air conditioner with this temperature sensor. Restores accurate temperature control when the thermostat fails to respond.

This evaporator coil circulates refrigerant inside the freezer compartment to absorb heat, allowing the refrigerator to maintain proper cooling. Replacing a damaged or leaking evaporator restores cold performance and reduces frost buildup. What it does

• Circulates refrigerant and absorbs heat from the freezer air to enable cooling.
• Helps maintain proper compartment temperature when functioning correctly.
• Can cause excessive frost, reduced cooling, or a warm freezer if cracked, corroded, or leaking.
• Works with the appliance's sealed refrigeration system and other cooling components.

• Disconnect power and empty the unit before starting work.
• Inspect and replace any damaged gaskets, insulation, or mounting hardware shown in your model's diagram.
• Follow OEM diagram instructions and use proper tools to avoid puncturing the coil or damaging nearby components.

This replacement tube routes water inside the refrigerator to properly direct drainage or supply lines, helping stop leaks and restore normal water flow. It's a direct-fit part used where original tubing has cracked or become clogged. What it does:

• Directs water flow for drainage or internal water lines
• Replaces cracked, split, or hardened tubing that can cause leaks
• Helps stop pooling or dripping inside the cabinet
• Restores proper routing of water to ice/water systems or drain channels

• One replacement tube as shown

• Disconnect power and shut off the water supply before starting
• Inspect fittings and clamps; replace any damaged hardware separately
• Trim tubing squarely and seat fully in fittings to prevent leaks

Replace your air conditioner filter drier to remove moisture and contaminants from the refrigerant system. Install when servicing the cooling system. Verify fit with your model number.

This blower wheel is the rotating fan impeller that moves cold air through the refrigerator/freezer evaporator and across the cabinet to maintain even cooling. Replaces a worn or damaged fan wheel to restore airflow. What it does:

• Fits onto the evaporator/fan motor to drive airflow through the evaporator and freezer/refrigerator compartments
• Restores proper circulation when a cracked, broken, or unbalanced wheel causes poor cooling
• Reduces unusual fan noise or vibration caused by damaged blades
• Helps maintain consistent cabinet temperatures by enabling efficient air circulation

• One blower wheel

• Disconnect power to the appliance before beginning any repair
• Access may require removing interior panels or the evaporator cover and disconnecting the fan motor
• Handle edges and sheet metal carefully; small fasteners or retaining clips typically secure the wheel to the motor shaft
• After installation, verify the wheel spins freely and the fan motor operates quietly

If your room air conditioner isn't cooling properly or making unusual noises, a damaged fan blade may be the cause. This part circulates air efficiently.

Replacement rail for your air conditioner. Installs on the unit chassis to provide structural support. Order a new rail if yours is bent, damaged, or missing.

Window filler kit for room air conditioners. Seals gaps between the unit and window frame. Replace if panels are cracked, broken, or missing.

Mounting hardware kit for room air conditioners. Includes screws, brackets, and fasteners needed to securely install your unit in the window frame.