Parts for Frigidaire TRS20WRHD3: 03 - Refrigerator Door Parts

The Door Shelf Support is an OEM part for Frigidaire refrigerators, designed to hold and support the shelves on the inside of the refrigerator door. This part ensures that door shelves are securely mounted, providing stable storage for bottles, condiments, and other items.  

Symptoms of a failing Door Shelf Support include:

• Shelves becoming loose or sagging
• Difficulty in keeping items securely on the door shelves
• Cracks or breaks in the support

Causes of a bad Door Shelf Support can range from normal wear and tear, to accidental damage, such as overloading the door shelves with too much weight or impact from moving items in and out. Over time, the stress of weight and use can lead to the supports becoming damaged. 

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Specs: 10 - 16 x 3/4 phillips truss head

Snap in

This factory screw fastens refrigerator components and panels. It replaces missing or damaged hardware so parts stay aligned and secure, reducing looseness and rattles caused by vibration. What it does:

• Secures panels, brackets, and trim per your model's design
• Helps maintain alignment and reduce vibration-related loosening or noise
• Replaces missing, stripped, or corroded hardware
• Restores a snug fit when threads or heads are worn

• One screw

• Disconnect power; turn off the water supply if working near ice or dispenser systems
• Use the correct driver; start threading by hand to avoid cross-threading
• Tighten until snug—do not overtighten to prevent stripping or cracking adjacent plastic
• Refer to your model's diagram to confirm location and quantity used

This factory fastener secures appliance panels and components. Replace a missing, stripped, or corroded screw to restore a tight, rattle-free fit and keep brackets and covers properly aligned.

• Fastens panels, brackets, and internal parts as specified by the manufacturer
• Helps maintain alignment and reduces vibration/rattling
• Replace if the head is stripped, threads are damaged, or corrosion is present
• Symptoms include loose/missing hardware, gaps, or rattling during operation

• Disconnect power; shut off gas/water if applicable before servicing
• Use the correct driver/bit size to avoid stripping the head
• Start threads by hand to prevent cross-threading; do not overtighten
• Match screw length/thread to the location; replace in sets when required

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.