Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Washer lid hinge attaches the lid to the cabinet, allowing smooth opening and closing. Replace if cracked, rusted, broken, or causing lid misalignment.
With the parts supplied from your company. The lady that took my order was good at her job. All the parts were correct and fit. I thank you for the service that recieved. Read more
Washer won't spin or makes noise during spin? This clutch spring cap maintains proper tension in the drive assembly. Quick 5-minute DIY repair.
I bought a clutch liner kit installed it in 5 minutes now it spins faster than ever. Read more
Knurled pin secures knobs or dials to control shafts in washers. Replace if the original is missing, worn, or damaged to stop loose or spinning knobs.
Weekend laundry became very noisy, our 1987 Whirlpool washer began doing a dance across the floor and the drum was banging into the inner cabinet. After doing some research and watching a few videos on Appliance parts pros website. I inspected the washer and noticed one leg the rubber coating disintegrated, decided to change all four legs, springs and lid switch. Hardest part of the job is getting the cabinet together. Ops check good. Read more
Secures the control panel to the washer cabinet. Replace if your console strap is cracked, broken, or missing, causing the control panel to sag or shift.
Gray acrylic spray paint for coating worn or chipped dryer drum interiors. Restores the protective finish when the original coating is scratched or flaking.
Completely removed dryer drum cleaned surfaces ready for paint applied paint acquired from you it did a wonderful job with one can of paint will use for a while and acquire another can of paint for second coat thank you so much for your help the whirlpool dryer drum paint was exactly what it said it would do Read more
Ground screw secures transmission housing and console components in washers. Replaces missing, stripped, or corroded screws. 10-24 x 3/8 inch fastener.
Replaced timer control unit, first time doing this. Read more
Leaking washer during drain cycle? This drain hose clamp secures the connection to prevent water leaks and hose pull-off from vibration or pressure.
Secures the balance ring to the outer tub in your washer. Replace if clips are cracked, broken, or missing, causing the balance ring to detach or shift.
The balance ring clip fell between the drum and the plastic tub. I watched the step by step video, went out and bought a tub ring tool to remove the tub ring nut and did not find the clip. I disassembled the machine further reviewing the video again. In the end the machine must have been apart before and there were 3 clips missing total. I ordered 8 new clips and replaced them and reversed the procedure to reassemble the machine once again watching the video putting the machine back to better... Read more
Screw-washer assembly secures panels and brackets in your washer dryer combo. Replace if worn, missing, or stripped to restore secure fastening.
Clothes not getting clean or agitator wobbling? This upper agitator restores proper washing action in top-load washers. DIY-friendly, 15-minute fix.
Washer not filling with hot or cold water, or stuck on one temperature? This temperature switch restores water temperature control. 5-minute DIY repair.
Replacing the temperature switch and control know was easy! Took all of about 5 minutes. Read more
Connects drain hose sections to prevent leaks and restore proper wastewater drainage. Replace if coupling cracks or connection leaks during draining.
Washer won't spin or vibrates excessively? This spring damper assembly cushions the drum during spin cycles, reducing vibration for smooth operation.
Prevents drain water from siphoning back into your washer tub. Replace if cracked, broken, or leaking. Installs on drain hose to maintain proper flow.
I bought a part and it worked perfectly. I was able to connect a flexible pipe to the siphon valve and set up a grey water system from our washing machine. Read more
Drain hose nozzle that attaches to the end of your washer's drain hose. Replace if cracked, broken, or missing to ensure proper hose connection.
Leaking water connection? This hose coupling creates a secure seal between your washer hose and water inlet, stopping drips and loose connections. DIY fix.