Kenmore Range 790.72403012 (79072403012, 790 72403012) Parts

My Kenmore 790.74139310 gas range was taking over 30 minutes to reach 350F. It used to take a little less than 10 minutes. The problem was the ignitor for the lower gas burner. It would glow but not pass sufficient current to increase the gas flow to the lower burner. Once at temperature, there is of course loss of heat when loading the oven with room temperature food. This took too long to recover, so we did not have proper temperature for proper cooking for the first 30 to 40 minutes. Food... Read more

After I came from from work, my wife told me about the problem. I quickly began to research the code F10 which according to the paper in the pouch behind my range said it needed a new temperature control sensor and that should fix it. It also said that if that doesn't fix the problem that I'd have to replace the circuit board which probably got fried due to the runaway temperature. So, I decided to just order the temperature sensor part# AP3963654 for $25.63 plus shipping. I ordered the part at... Read more

Before we replaced the board, my wife tried to replace just the element. We had one we had ordered several years ago when this same thing happened. When that didn't work we replaced the board and could see where the old board was damaged so we figured this was the solution. It would have been except the bottom element my wife used to replace the old element (which was fine but had been thrown out figuring the new one was new so why keep the old one) was 1" shorter in the back than the old... Read more

Replaced ignitor. Very simple project. Read more

Ordered replacement parts Read more

Ordered replacement parts Read more

Thanks, I’ follow the instructions on YouTube and my repairs was completed. Read more

I tried swapping the cables around by putting the cables from the burners that would light onto the ones that didn't light. When I did that the problem would move. So this is how i determined that the issue was with this module and not the burners or cables. Once this new module arrived it was simple to disconnect the old one and put the cables back on the new one. I tested it (holding by breath!) and then all of the burners started. HOORAY! Read more

We ordered a igniter and a new regulator. My husband installed the parts it works great now. Read more

Ordered new Ignitor / Orifice and screws Mike was a great resource, he helped me thru the project. Read more

The clips on the rear side of the drawer box were broken. Easy to locate the part on the website. Part in hand in two days and installed in about five minutes. Needed to remove the drawer and use a 1/4" driver, remove the broken slide and install the new one. Read more

It took a little longer then I was hoping but wasn’t terrible. If the burner is very old at all make sure to get the new screws. Both of mine snapped when trying to remove them. The new one works great. Read more

The bottom drawer glides tend to wear. The metal drawer sliding against the plastic glide creates a groove. After only a couple years, the groove was so large that the drawer slid in too far. It was no longer flush with the oven door. Then the left side was crooked!!! All it took was a screw driver to install these new glides. Read more

Ordered new Ignitor / Orifice and screws Mike was a great resource, he helped me thru the project. Read more

Had to pull double oven and range top out from wall which involved removing the upper kitchen cabinet. Took the sheet metal off the back and had the socket swapped out in a couple of minutes. My old oven works like a charm! Read more

Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more