Ge Peb2060sm1ss Parts

• Won't start

Removed and replaced 3 door switches and mounting bar that holds switches plastic gets brittle with age and each switch comes out slightly different from each other, the chances of breaking a mounting pin is very easy. care should be taken when snapping mounting bar back into place to insure top latch and bottom latch locate properly insure bar is proper aligned when tightening screws their is free play in mounting bracket that could affect door properly engaging switches. NOTE that their are... Read more

I read on line about other such ovens doing the same thing mine was doing, absolutely nothing! I even read stories of a major retailer telling customers to throw the microwave away. There's nothing you can do to fix it. After replacing a simple fuse that I ordered from you, the Advantium is as good as new. It took a grand total of 5 minutes to make the repair. The shipping cost more than the part, but it was all very worthwhile. Read more

Removed and replaced 3 door switches and mounting bar that holds switches plastic gets brittle with age and each switch comes out slightly different from each other, the chances of breaking a mounting pin is very easy. care should be taken when snapping mounting bar back into place to insure top latch and bottom latch locate properly insure bar is proper aligned when tightening screws their is free play in mounting bracket that could affect door properly engaging switches. NOTE that their are... Read more

• Tray won't turn

I bought a new rotating ring assembly and now it works again. Read more

14 year old GE Profile microwave wouldn't heat, but had power. Read reviews here. Ordered triumvirate of magnetron, capacitor, & diode. Was hoping not to need the capacitor as this was an expensive part; and if not needed to return to AppliancePartsPros, which has been SOP. After watching a couple YouTube videos of microwave capacitors being shorted, I made a capacitor discharge tool ordering 24W 100K Ohm resistor and high voltage test wires w/ alligator clips from amazon. At the same time,... Read more

I took the advice of another buyer and replaced the magnetron, capacitor, and diode from my microwave (make sure you discharge the capacitor). It was not a problem at all to do, I did find an excellent video on YouTube on how to test all of these components and almost anything else in a microwave. It’s called Microwave Oven Troubleshooting in Minutes- Step by Step by electronicsNmore. It was the best thing I watched. Turns out my magnetron was the only thing that was bad and it’s the most... Read more

Replaced the high voltage diode. You will need a special Torx screwdriver to remove the tamper resistant screws holding the cover. Once the cover is removed there should be a packet inside containing a schematic and detailed troubleshooting instructions. I used extreme caution to discharge the capacitor. The rest was simple. One screw and a push connector to remove and reinstall the diode. I fired it up and it was good as new. Thanks to AppliancepartsPros for the good guidance and extremely... Read more

• Tray won't turn

When our turntable stopped rotating, I would hear a clicking sound each time I used our microwave, like something was not properly engaging in order to turn the glass tray. Even though our microwave was 10 years old, everything else worked fine. I did a little research on the internet and found a couple YouTube videos that showed replacing the small motor in the bottom of GE microwaves. I am not a mechanical person, but it looked fairly easy, so I decided to try it. The... Read more

Replaced damaged switch but in the meantime broke part of the board latch. So, replaced that too. Read more

I researched the problem and found that not only was the fuse blown but the cause was a bad thermostat. Using the model number AppliancePartsPros.com. sold me the right parts for the right job. Read more

I ordered a replacement tray from you. Great service. The part arrived quickly. Read more

Replaced the magnetron, diode, and interior light. Read more

After researching on the internet, I decided replacing the wave guide cover would be much cheaper than replacing the microwave. Plus I couldn't even find one that worked with the existing trim kit. Had a bit of difficulty removing the old cover, but the folks at Appliance Parts Pro answered my email question within 24 hours. I received the replacement part a day or so later. GREAT CUSTOMER SERVICE! Thanks! Read more