Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This dryer exhaust fan is used on some Admiral, Crosley, Hoover, Magic Chef, Maytag, Montgomery Ward and Norge brands. Size: 3-1/8 inches deep, 7 1/2 inch fin diameter, 6 3/4 inch hub diameter, 20 standard fins, 1/2 inch diameter motor shaft, 7/16 inch diameter motor shaft to flat side of shaft. Blower wheel clamp not included. For the clamp order 25-7855.
Kit includes door switch and mounting clip. For the switch only order WP53-0148.
I replaced the door switch Read more
Made for most Admiral, Crosley, Norge, and Magic Chef dryers. Kit includes 2 drum support rollers, 2 support shafts, 4 screws, 2 spacers, 2 washers, 2 retaining rings and instruction sheet.
Decided to order the kit with both rollers even thou the right one looked OK.Also ordered the pulley for the idler. Watched the video for the pulley installation,super helpful on a couple of the steps!! Everything went great. A 14 year old dryer still has life! Parts ordering and delivery was also great!!! Thank you. Read more
Removed the front to look & listen,found the blower wheel spinning freely on the shaft,the flat was completely gone & rounded out.When I relieved the belt tension I found the bushings were gone out of the idler pulley as well replaced the belt for preventive maintenance while I had it apart.Also a good opportunity to use a shop vac to clean the lint from the inside. Read more
One of three coils, to get all three order 12001348
I replaced this solenoid gas valve coil after testing it for continuity. It worked! Read more
When I pulled out the dryer from the wall, I could see dust/lint had accumulated everywhere and the vent system was compromised. I vacuumed up the dust/lint accumulation outside and then inside the vent system. I then opened the lower cabinet to clean and check its condition. I removed the water steamer bottle and its sub-assembly and then the drum. After cleaning and inspecting components — both visually and with a multi-meter I determined the problem was the appliance doing what it was... Read more
This is the door switch only. For the door switch including the mounting clip order LA-1005.
I first unplugged the dryer, lifted the top of the dryer, then removed two screws that hold the front panel to the side panels. I removed the cable clip that holds the wires for the switch to the front panel, and removed the wires from the switch. I then removed the switch from the clip that holds the switch in place. My original switch had only one connection at each end, but the replacement had two at one end and one at the other. The terminals at the one end were labeled NC and NO. I... Read more
This was a Maytag DE312 actually a Whirlpool labeled as Maytag) and is 27 years old. Replaced motor, drive belt and drum rollers. One tricky part was the motor because the new motor comes with integral starter and it was necessary to cut off existing female spade connectors on some wires and crimp on new connectors. Instructions were adequate but need to be carefully followed and a decent electrical stripping and crimping tool must be at hand. I bought a new motor drive pulley because another... Read more