Hss25gfph Ww Parts

I replaced the solenoid, door, spring and bucket. The bucket cracked from ice freezing inside it. Ice froze inside the bucket because the solenoid stopped pulling the door closed which allowed hot humid air into the freezer. While I was in there I replaced the dispenser door, spring and crank because they are cheap and the old ones were moldy. The mold is most likely from the door not closing and causing condensation on the parts as well. Read more

I ordered the parts from you and put them right on. I had no problem at all very happy with your parts and was amazed at the time it took to get my parts. I will make sure I ordered from you again. Thanks. Read more

Replaced the support bracket for the ice bucket. Replaced the auger motor for the ice dispenser and installed the new coupler for the microwave tray to spin. Everything works great now! Read more

Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge. Read more

I replaced the upper and mid spray arms and bearings, removed filters and screens and cleaned everything. Pulled pump and replaced the connector and the collection sump. Repair took about 3 hours and went very smoothly thanks to the AppliancePros video! I'm on the east coast so I could not believe it when the parts arrived less than 24 hours after I placed the order! Prices were great too . . . I'm a customer for life and my dishwasher cleans the dishes like new now! Read more

Installed new stainless steel pan replacing broken original plastic pan and installed new rubber grommets for the compressor Read more

The auger gearbox shaft had a spot that was stripped of threads which prevented the auger drive from spinning the ice down the chute. I replaced the auger motor/gearbox assembly, the auger drive as it had to be cut off the shaft, and the 3 mount bolts that hold it all in place. Whole job took 30 minutes from start to finish which included cutting off the drive bracket. Read more

Replaced the housing the water filter screws into. Water works fine now. Read more

Went to appliance parts Web site looked at the symptoms ordered the suggested parts, my favorite was watching the part repair video, on what the part does and how to install, got the parts the next day, defrosted the fridge 100%, and one by one installed each part what an easy process the video showed exactly where the part was located and how to remove the old and install the new one, now my fridge is working and cooling better than before I saved over $1,400, didn't have to buy a new... Read more

The diverter was broken and looked like housing also, so replaced both and now works fine Read more

The problem was most likely the evaporator fan motor but it could have been a bad blade, loose parts or bad motor mounts. Hard to tell without taking everything apart and inspecting. Since fridge was 17 years old I decided to order the entire evaporator fan assembly as shown in the parts diagram including fan blade, motor brackets, motor, motor mounts, screws, etc. Getting to the assembly involved removing the ice maker unit plus the entire rear inside of the freezer section. Parts cost around... Read more

Evaporator fan motor in our freezer was bad. Ordered new one with 2 day delivery and had it in 2 days. Thankfully it was very easy to get to from the front of the freezer. There are 3 different options for same motor with different wire harnesses. I bought the cheapest option and then snipped and reconnected the wires to the existing harness. That saved us $50. Still well under an hour from the time I opened the tool box to putting the last tool away. Fridge is now plenty cold even set on 5. . Read more

I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went... Read more

Easy fix once I found the problem. Broken solenoid sleeve. Part cost $2.58 + shipping. 10 minute repair. Read more