Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
I ordered the replacement burner and replaced the burner when the part came in. Read more
This genuine replacement part is an oven control board. The oven control board is the main circuit board that controls the ovens' essential functions. If the oven isn't heating properly, not turning on, or showing an error code on the digital display, it might be time to replace the control board. Replacing a control board may seem like a difficult task, but it is a relatively simple process. Start by unplugging the range. After that, move the appliance away from the wall to gain access to the back. Remove the upper back panel, and locate the control board. Take note of the orientation of the wires using a phone camera. Then detach the wire harness from the old control board. Remove any individual wires with a pair of needle-nose pliers. Then re-attach the wires to the new control board in the correct terminals. Snap the new control board into place and re-install the upper back panel of the range.This OEM replacement part is compatible with General Electric, Hotpoint, and RCA brand ovens.
A very common problem with the GE oven is the dreaded F7 error code. I purchased the control board as well as the keypad and replaced both. The error code could have been either part but since I saw a lot of grease, I chose to change out both even though I isolated the problem to the keypad only. By resetting the error first by hitting the clock button on the keypad, turning off the power,disconnecting the keypad, then turning back on the power if the code doesn't come back it's the keypad. ... Read more
Tenants in rental unit explained problem, I ordered replacement hinges for both the left and right. After replacing both, it was determined that a cleaning person removed and didn't reinstall the bottom heat plate of oven back into position, which was the reason the door wasn't closing. Read more
Using the website, I looked at the schematics and guessed which parts I'd need. I chatted with an associate, who confirmed the requirements. He also sent a PDF on how to take the old parts off. I'm not mechanically inclined, but the effort went flawlessly. Thanks for the parts and help! Read more
On line guide and past training Read more
Pulled out the old and replace it with new part. Read more
All of the information on the web repair sites said "replace the hinges as the springs are worn out." Didn't fix the problem. The top of the door still wouldn't seal, and the. Leaning latch wouldn't catch the door unless you pressed on the door. The inside panel of the door was fatigued. Too many turkeys were set on the door over the years. The hinges are attached to that inside panel, so the stress points were bent over time. I replaced the inside steel panel. Took about an hour. Was able... Read more