Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
Follow the trio ubshooting flow chart inside of the microwave panel - and read articles on this website. Turned out to be a thermostat that had popped and gone bad. Replace the thermostat and it is good to go. Read more
There are four screws that hold the handle in place, my handle was down to one. I had to pry off the inner door cover. I used butter knives, but a thin screwdriver should work as well. Start on the outside edge (away from the hinge) near, but not in, the upper or lower corner. Slip the knife in between the inner door cover and the outer door shell, gently pry loose, working around the cover. It isn't necessary to remove it entirely, but I did so that I could clean it. This exposes two of... Read more
Went shopping for new microwave with wife. Lucked out. Couldn't find one she liked. Went home, took door apart, ordered part. At the door the next day, put back together in 5 minutes. Walla, saved hundreds of bucks. Thank you Appliancepartspros. Read more
Found coupler completely loose, shaft attachment point disintegrated; melted? On motor, plastic-like material stuck on shaft. Easily found matching microwave model on AppliancePartsPros.com and matching parts. Oddly, like other appliance parts sellers, the motor was listed for about $60, but a second equivalent one for about $23. Photo matched original. Ordered the cheaper motor + coupler, perfect matches to original. Motor is easily accessible by easily removing the microwave bottom cover with... Read more
I have one of those combo units with the microwave on top and the oven on the bottom. The thermometer switch located on the upper right side mounted on top of the magnetron read open on a continuity test. Replaced the thermal fuse. Everything works fine now. Note: The thermal switch on the left side read closed, the fan switch on the lower right side read open. I just watched some youtube videos on what and how to test the components. The 20A fuse was good. So I tested the thermal... Read more
I ordered a part from GE Read more
Removed front vent cover held on by two thin Phillips head screws. At the top of the panel was one screw. Removed screw holding panel in place. I then slid panel up out of grooves and had to use small thin flat head screw driver to release catches on the sides of panel. Snapped new on in place and reassembled. Read more
Ordered a new motor, put it in, and it works fine! Read more
Ordered new film, cut to size with a T square and an exacto knife, use old film as a template. Round corners with a nail clipper. Apply to inside of door, good as new in 15 minutes! Great service, speedy too. Read more