Mah4000awwn T Parts

Basically rebuilt the washer from the ground up. Spent more money than a new washer but we have been so happy with the way this machine has worked over the last 19 years figured it would be money well spent. Read more

• Leaking

Took off cover, installed new parts. Read more

Got good advice. Parts in two days. To and running in an hour. Read more

• Leaking

Replaced the tube and the clamp Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more

After disconnecting power, removed rear access panel. belt was already off. Removed bolt washers at center of pulley, removed pulley.installed new pulley on to drum shaft. Installed washers and bolt with blue thread locker applied to threads. Installed new belt. Reinstalled rear access panel. Reconnect to power. good to go! Read more

I simply replaced the back cover, it only took 1 screw. Then I replaced the thumb screw as well. It took less than 5 minutes. Read more

Replaced coils on gas valve; while at it replaced door screws which were starting to wear from assorted repairs over the years. Read more

• Leaking

Here's the story. All my appliances except the dryer broke. Yeah. talk about bad luck. First I tried to fix the refrigerator. Replaced both motherboard and inverter board. Now it wakes up but the compressor does not kick in. Need another part. The washer, well I have to pull out the sink to get enough room to pull out the washer to fix it. Since the refriigerator is still in the middle of the kitchen, I don't need to tear apart another room. Nevertheless, let me say this, I love my "older"... Read more

It was a nice match thnx alot Read more