Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
This OEM part is a timer for washing machines. The timer is the part that controls the desired time of the wash cycle. Over time, a timer can become inoperable after excessive use. If the timer motor has shorted, it will stop functioning properly. If the timer is no longer operating properly, it will need to be replaced.To replace the timer, start by removing the control panel of the washer. The control panel can be removed by unthreading the mounting screws that secure it. Once the screws have been removed tilt the control panel up to gain access to the timer. Once located, take a pair of needle-nose pliers and grab the centerpiece that rotates. Once the pliers have locked onto the centerpiece, proceed to pull off the timer knob from the front of the control panel. Then pull the timer dial off. Disconnect the two wire harnesses. Once these wires have been removed, slide the timer out from its place. Take the new timer and line it up with the four mounting tabs. Slide it in so the locking tabs lock into place. Reinsert the wires in their correct terminals and secure the control panel.This genuine replacement part is compatible with Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, Sears, and Kenmore brand washers.
Replaced timer, following your How-to video. Worked perfectly, very easy to do. Total cost $145 (including overnight shipping).. Would have cost $460.00 to have appliance repair company do the same thing. Super pleased. Read more
I figured it had to be the flume; changed the flume and hose, mounting screws Read more
I replaced the worn parts. Removed the electric motor/pump assembly then took it to my motorcycle repair shop to clean/maintenance the motor, remove the old pump because it was stuck on the motor shaft. Once removed I blew out dust/debris from the motor w/compressed air. Sanded and filed the corrosion off the shaft, applied a "sealing grease" of sorts to the shaft to make potential future removal easier and reassembled. I took the whole wamma jamma home, reinstalled and wah-la, fixed. I am... Read more
Replaced timer in less than 5 minutes along with timer knob. Read more
Replaced mixing valve Read more
New timer. New water level switch. Works fine now. Read more
I replaced the friction ring, counter balance spring and all six of the tub rings. Though not a terribly difficult repair it was time consuming as the cabinet had to come completely off to access the rear of the tub. Once all of the springs were removed it was easy to slide the tub to the side, tip it and remove the old ring. Replacing it was just as easy. Replacing all the springs was made more difficult due to the additional tension the new springs had. I believe the total repair took me... Read more
Our dryer is next to an exterior wall and the washer right next to the dryer. I wanted to drain the washer water outside. I easily connected the existing washer drain hose with one of the two new drain hoses, attached the hoses in two locations to the wall with a 'U' bracket, drilled a hole in the outside wall, and ran the new hose outside. The planter I want to water is on the other side of a narrow walkway and about five feet from the house wall. At the end of the first drain hose, I... Read more
.watch youtube videos they're very helpful Read more