Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Removed the drum and replaced the bearings, bearing seal, seal between front and rear outer drum, shocks, and lid. It would be helpful to others to also go over an unit that has the controls in the rear as mine does. You simply unclip the lid in the front, take out the four screws for the soap dispenser and lift the lid up and do not have to remove it at all. Also, I found two screws at the bottom of the front panel below the filter and pump drain hose access that had to be removed before the... Read more
I ordered the door from Appliance Parts Pros, which was on back order. When it arrived I had already removed the broken door. Please be sure to save your parts as the new door only came with one bushing for the door. Read more
I explained to the representative the piece that was missing on my washer. I had given him the model number etc. He was very helpful to make sure I got the right part he checked it three times just to make sure it was right. I received the part in a very timely matter. I would not hesitate to have them help me again. Im going to store them in my favorites if need part for an appliance again. Thanks again K. Jeanette Read more
Size: 4 3/4 inches. Used to secure the washer tub before transporting. They must be removed before using your washer.
This front load washer drive motor stator includes the rotor position sensor switch (RPS). For the RPS switch only order 6501KW2002B.
This seal has a drain hole. If your model does not have a drain hole, order part# 4986ER0001A.
Repairman Read more
My washing machine had become increasingly loud during the spin cycles and you could feel a slight resistance when manually spinning the drum. I watched the bearing-replacement video on the website which was for a slightly different model with front mounted controls so I also downloaded the service manual to see how to disassemble my specific cabinet and controls. Once I had the washer disassembled and the tub & drum out I determined that bearing seal had failed and water had started to... Read more
This part may be black or gray in color.
I ordered a replacement part from AppliancePartsPros.com and it arrive the next day! Read more
This water inlet valve is a genuine OEM replacement part that is sourced directly from the manufacturer for use in washing machines. The water inlet valve is the gatekeeper for the water flow into the washer. When the operator sets the wash cycle, the solenoid fires up and tells the valve to open the gate for hot or cold water or both to fill the washer tub. When the tub has filled to a preset level, the valve gates close and the water flow stops. If this valve fails, the water will not stop and will eventually flood or the water might not be signaled to flow at all. This repair requires a Phillips screwdriver and pliers. Disconnect the power source and turn the water off before working on the washing machine. Remove the back panel from the washer and locate the inlet valve. Disconnect the hoses from the valve. Remove the damaged valve. Install the new inlet valve. Connect the hoses in the same order they were removed and put the back panel on the washer. Reconnect the water and power.This water inlet valve is made of molded plastic and is individually sold. It does not include screws. It is made specifically for washing machines manufactured by LG.
I found other posts on AppliancePartsPros.com to be helpful. Most people and pros indicated that it was the Cold Water intake valve which has 4 solenoids on it. I watched the video to replace the Hot Water valve which is right next to it. My washer opened differently than the one in the video but it was not hard to figure out. Tools needed; Philips screwdriver and pair of regular pliers. I took the screws off of the small panel on top on the back of the washer. This allowed the control... Read more
Sensor assembly Read more