Kenmore Refrigerator 795.78402801 (79578402801, 795 78402801) Parts

• Leaking

Removed the old line and replaced with the new. This is the sixth time I've replaced the line. Yes you read that right, the sixth time. Lines fail about every 6-8 months so I can change one out now in about 10-15 minutes. Bought the refrigerator in Feb '09 and the line first failed in March 2012. Since then I've had failures in as little as 4 months to as much as 9 months. Frustrating to say the least, but I'm a whiz at changing out the line :-) Read more

• Light not working
• Not dispensing water
• Ice maker not making ice

I watched the repair video and I replaced the switch. I ordered the switch on Friday and the part came the next day. Amazing. Read more

• Doesn't shut off
• Fridge too warm
• Noisy

Removed 2 screws from mullion strip heater and slid it up off the tabs at top and bottom. Unhooked the plug and removed it. Verified proper mullion heater and then plugged wiring connection back together, positioned slide clips back in line and slid mullion down onto the clips. Tucked the wiring back into opening positioned cover back in place and reiinstalled the 2 screws. It took about 10 minutes for the entire job. the 2nd problem was a noisy evaporator motor and is a more intense repair... Read more

1. Googled "appliance replacement parts" - found two sites to consider 2. Researched parts needed via a exploded diagram - can't fix it if you can't name it. 3. AppliancePartsPros.com had the easiest diagram and after checking, the lowest price. 4. Parts showed up within a couple of days - an in-transit note was helpful. 5. The part screws in but watch out you don't break the tiny black pin holding the part on in addition to the screw. Needed JB Weld to fix that. Read more

Elderly neighbor charged $100 for factory tech to inform her that the part wasn't available anymore, so I ordered 2 from Appliance Parts Pros.com (one for a spare) and when they arrived a few days later, I installed then in about 20-25 minutes. I had to remove all the food off the door shelf so I could lift the door off the hinge to replace the bushing. That took 5 minutes. Shame on the tech that went by the date of manufacture rather than checks by model and serial number to see if the part... Read more

First, water and electricity don't mix, so make sure to unplug your refrigerator before beginning this repair - it shouldn't take more than an hour, so you shouldn't have to worry about spoilage. My water dispenser began making a hissing sound from the back of the fridge when you pressed the dispenser. Upon inspection, I discovered the 1/4" feed line into the filter housing assembly had cracked. I ordered the 1/4" feed and 5/16" return lines, figuring to replace the return line while I was back... Read more

Purchased replacement slides. These were very easy to install, 3 screws on each side and re-installed the basket. Read more

Was able to diagnose problem at AppliancePartsPros.com by entering the model #. This is apparently a common problem with this Refrigerator Replaced Light Socket Assembly, Lamp Reflector, Lamp Case and Lamp Cover. Also replaced the main circuit board (not sure if this was necessary). The wiring on the Light Socket Assembly was different than the original, so it was a bit confusing how to assemble it, and no screws were provided to attach it to the Lamp Reflector - figuring this out took most... Read more

Ordered parts, removed top tray in freezer, popped the back inside freezer panel out removed and replaced fan, dampers and fan housing. Took about 15 minutes. Read more

I ordered the parts and they arrived in 2 days. While the parts were in transit, I watched the video concerning replacing the gasket holder. WHAT A LIFE-SAVER! From start to finish took less than 60 minutes!!! Note: I did take some water and ran it down the channel where the gasket goes to make it easier to slide onto the gasket. Read more

I ordered the parts and they arrived in 2 days. While the parts were in transit, I watched the video concerning replacing the gasket holder. WHAT A LIFE-SAVER! From start to finish took less than 60 minutes!!! Note: I did take some water and ran it down the channel where the gasket goes to make it easier to slide onto the gasket. Read more

Had a local company in to estimate repair of gas range oven door glass that had fallen out. At this time had him provide me with an estimate for replacing the freezer door gasket because on several occasions recently the freezer door has frozen closed.His estimate was $110.00 for the part and $140.00 for the labor. He would need to order the gasket and needed 3-4 days to get it. I watched your video ordered the part for under $50.00 total . I received it within 2 days and installed it in under... Read more

Just slipped in. The hardest part was finding one to fit. The online customer service center chat was immensely helpful. Found the right one and it came within a day or so. Excellent service. Read more

I removed the defrost sensor assembly, installed a new one, it worked. Because of a shipping problem with FEDEX, Appliancepartspros resent the parts not once but twice. Needless to say, they are my go-to source for parts from now on. Read more

The old filter head was broken at the supply line side connector fell out. The clicking noise eventually caused the fridge to warm up and stop cooling. The clicking was the overload relay tripping. The Start solenoid on the compressor was an Embarco TSD part 513604044. APP does not have that part nor does any else found a similar one on ebay but I ordered the PTC assembly 6749C-0014E. I removed the overload relay and capacitor from the TSD used two pieces of wire and connectors to create the... Read more

I ordered a new part from AppliancePartsPro.com on Friday at 4:20PM. It arrived the very next day - Saturday at 10:30AM!!! I was shocked and amazed that the part was not only correct but that it arrived at my door in less than a day. Read more