John L Holly Hill , FL September 22, 2020 Appliance: Whirlpool Refrigerator WRS571CIDM02 In door ice maker inop Replaced both inlet valves, no joy. Upon further inspection, found ice maker harness extremely tight at lower freezer door hinge, clamped in place right at a pivot point. Essentially the harness is held in place and rotates with the door. 6 wires broken inside. Splice repair and ice maker now works. Most likely will have to replace harness eventually. Unless there is more slack inside the freezer door this will probably happen again. Very poor design. Read More... 37 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Dennis B Abingdon , MD March 20, 2015 Appliance: Whirlpool Refrigerator GSF26C4EXB00 Water leak under refrigerator Found the proper part through Appliance Part agent. Ordered it on a Monday, and received it the next day! Had a small problem with water outake tube, so I called Appliance Pro, and again received helpful information, Thanks. This has been the third time I've used Appliance Pro, and will continue to do so in the future. Read More... 17 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Jeffery P Fishers , IN January 05, 2021 Very slow water from in door water dispenser. Replaced both water control valves. This unfortunately did not fix the issue but was an important troubleshooting step. After replacing both valves and having the same issue I troubleshot the water path, single control valve - up to filter housing - down to the water cooler/reservoir "S" (made sure this was not frozen and blocked) - back to double control valve) and narrowed it down to the water filter housing being a restriction. We don't use a water filter as the fridge is plumbed to the RO system. I bypassed the filter housing (and the water cooler/reservoir) with tubing directly from the single control valve to the double control valve. Water pressure out of the dispenser is now normal. Items to note. 1. the fridge locking feet use a VERY small 1/4in wrench.. make sure you have a wrench that small 2. the backside of the fridge was relatively clean. The compressor, fan, drip pan were MUCH cleaner than expected (Good design) 3. coils can be cleaned from the FRONT without having to pull the fridge out (Good design) Read More... 15 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Nut Drivers, Screwdrivers, Wrench Set
Susan B Chandler , AZ July 01, 2017 Appliance: Model WHIRLPOOL REFRIGERATOR The water dispenser solenoid was leaking at a connection I replaced the assembly myself. I had to turn off the water supply at the wall and disconnected two water hoses (water supply and water feed into the refrigerator). I pulled the old assembly by removing two screws. I unplugged one electrical connector. Reverse the process to install the new part. It was a simple ten minute job. I saved over a hundred dollars doing it myself! Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Adjustable Wrench, Nut Drivers
Deborah G Deming , NM November 02, 2018 Leaking valve in the refrigerator water system which flooded the kitchen when we tried to get a glass of water Purchased a new valve from you. Called a plumber to install it. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench, Screwdrivers