Fghd2472pf0a Parts

Replaced racks, Read more

Replaced upper rack (it comes with wheel assembly). The only tricky part was removing spray bar from old rack. Read more

The door cables attach to springs that help the user open/close the dishwasher door. I attached the new door cables to the springs then attached springs to the intended mounting locations on the door. However, the new cables were shorter than the originals. This created enough tension in the springs to cause the door to close by itself. I was forced to change the springs' mounting locations. Fortunately, I was able to attach the springs to cut-outs in the door that reduced spring tension. ... Read more

Installed this part Read more

This was a pretty easy fix. Removed the screws around the perimeter of the inside cover of the door and pressed the outer door cover upward to release it from slots retaining it. There are four wires to remove (2 for the detergent door release and 2 for the rinse agent release). Removed the 6 screws retaining the dispenser assembly and inserted the new one. Reassembly is simply in reverse order. Problem solved for less than the cost of a service technician's call! Read more

Replaced racks, Read more

Replaced upper rack (it comes with wheel assembly). The only tricky part was removing spray bar from old rack. Read more

I would open door after initial fill and noticed little or no water. I also could not hear water flowing from control valve. I replaced the water control valve and issue resolved Read more

The gasket is fairly straightforward: it's just a press-fit right in to the channel. What you need to know is that you need to stretch the gasket material lengthwise prior to installation; if you don't it will be too short. The problem is that the bottom seal is not included with this gasket kit. The bottom seal begins to loosen at the corners and then begins to allow water past the door. The only way the bottom seal is sold is as part of the inner door assembly, which is costly. I removed... Read more

The gasket is fairly straightforward: it's just a press-fit right in to the channel. What you need to know is that you need to stretch the gasket material lengthwise prior to installation; if you don't it will be too short. The problem is that the bottom seal is not included with this gasket kit. The bottom seal begins to loosen at the corners and then begins to allow water past the door. The only way the bottom seal is sold is as part of the inner door assembly, which is costly. I removed... Read more

Ordered a new pump and installed, took about 15 min. Reinstalled the dishwasher and tested still not draining. Disassembled and checked for pump power and found no problem. Removed drain hose from pump housing and found a blockage cleaned out blockage and hooked up the shop vac to drain hose under sink and made sure it was clean. Reassemble and reinstall with old pump, works great! Guess I now have a spare pump in stock. Read more

Surfed the web, got advice, ordered the part, shut-off the electric power, disassembled back panel of door, removed wires for old switch and installed onto new electric door latch. Reassembled door panel - it is a little tricky, need some patience to get it all together, but it does go easily. Read more

Replaced trap Read more