Parts for Whirlpool WGD560LHW1: Top And Console Parts

Replaces the upper cabinet cover of your dryer. Needed when the original panel is dented, rusted, warped, or damaged. Restores a secure fit and clean look.

This 8-18 x 5/8-inch screw secures dryer panels, brackets, and covers. Replace missing or stripped fasteners to restore a tight fit and stability.

Secures dryer panels and components in place. Replace this mounting bracket when cracked, broken, or missing to restore stable alignment and eliminate rattling.

Console mounting bracket for dryers. Secures the control panel to the cabinet. Replace if cracked, bent, or broken to restore proper console support.

Fix a dryer that won't start, stops mid-cycle, or has unresponsive controls. This main wire harness restores electrical connections between components.

Fix a washer with no beeps or cycle alerts. This speaker restores button press sounds and end-of-cycle signals. Simple repair, typically 15-30 minutes.

No lights on display or unresponsive buttons? This dryer control panel restores all cycle settings and displays. Fits Whirlpool electric and gas models.

Identification label displaying model, serial, and rating information. Replaces faded, damaged, or missing name plates on appliances to restore appearance.

This wire harness routes power and signals between appliance components to restore reliable electrical connections and proper operation. It replaces damaged or corroded wiring to help eliminate intermittent faults and loss of function. What it does:

• Provides the factory-style wiring paths and connectors for the listed appliance circuits
• Restores power or signal continuity when original wires or connectors are frayed, burned, or broken
• Helps stop intermittent operation, shorts, or components that won't receive power
• Matches OEM connector ends and routing for a like-for-like replacement

• One complete wire harness assembly as shown

• Disconnect all power (unplug or switch off breaker) before servicing to avoid shock or injury
• Compare new harness to the old unit before installation
• Handle connector terminals gently; avoid bending pins or pulling on individual wires
• Secure harness with existing clips or ties and verify connectors are fully seated before restoring power