Parts for Lg WT1001CW: Top Cover Parts

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.

This screw cap covers and protects an exposed screw head or mounting hole, restoring a clean, finished appearance and helping shield the area from dirt and moisture. Use it to replace a missing, cracked, or discolored cap.

• Conceals and protects a visible screw head or mounting hole
• Helps keep dust and moisture out of the opening
• Restores a clean, factory look when the original cap is lost or damaged
• Common symptoms: cap missing, cracked, loose, or won't stay in place

• Disconnect power and shut off water when working near electrical or moving parts
• Align the cap over the screw head or hole and press evenly until fully seated—do not force
• If removing an old cap, use a plastic pry tool to avoid scratching nearby surfaces
• Ensure the underlying screw or fastener is properly tightened before installing the new cap

This switch assembly is the microwave's door interlock module. It mounts to the latch board and contains the switches that confirm the door is closed, restoring consistent start/stop operation when worn or sticking switches cause intermittent "door" errors.

• Houses and positions the interlock micro-switches on the latch board
• Signals the control that the door is securely closed so the unit can run
• Common fixes for: won't start, stops when the door is jostled, "door" error messages, or runs but doesn't heat
• Helps correct intermittent operation caused by fatigued or misaligned switches

• Disconnect power before servicing; microwaves retain dangerous high voltage
• Remove the upper grille and control panel to access the latch area per your model
• Note wire locations and switch orientation; move connectors one at a time to the new assembly
• After installation, verify door latching and test operation before reassembly

This softener cap is the small replacement lid for a washer's fabric softener dispenser. It helps contain and direct liquid softener into the dispenser so the machine releases it at the correct time for softer, evenly rinsed laundry. What it does:

• Seals the softener dispenser to prevent drips and spills during filling and cycling
• Directs liquid softener into the dispenser chamber for proper delivery during the rinse
• Helps prevent softener from pooling or leaking into the wash tub between cycles
• Common symptom: softener leaks, pools in the dispenser, or is not dispensed properly

• Disconnect power to the appliance before servicing to avoid injury
• Remove the dispenser drawer or access panel per your model's service instructions to reach the cap
• Press or snap the cap into place until it seats securely; avoid forcing or using excessive tools

This is a replacement door hinge that supports and pivots the refrigerator/freezer door for smooth opening and proper alignment. Restores secure door movement and helps maintain an even seal for reliable cooling. What it does

• Provides the pivot point that lets the door open and close smoothly
• Keeps the door properly aligned to prevent rubbing, sagging, or gaps
• Helps the door form a consistent seal to maintain internal temperature
• Commonly replaced when the door drops, squeaks, or binds during use

• Disconnect power and remove food from affected door area before starting work
• Support the door while removing and installing the hinge to prevent dropping or damage
• Use proper tools and follow manufacturer torque recommendations for fasteners

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.

This damper assembly cushions and stabilizes the appliance drum/inner tub to reduce vibration and prevent sudden shifts during operation. It helps keep the drum aligned for smoother, quieter cycles and more consistent performance. What it does:

• Absorbs and reduces drum/tub movement and vibration during spin and agitation
• Prevents abrupt drops or slamming that can cause noise or wear on other components
• Helps maintain proper drum alignment for even load handling and smoother cycles
• Commonly replaced when owners notice banging, thumping, excessive vibration, or a sagging drum

• One damper assembly

• Disconnect power (and water if applicable) before beginning service
• Access typically requires removing the appliance back or front panel; follow the OEM service manual
• Use hand tools; avoid forcing parts—inspect mating mounts for wear and replace if damaged

This friction damper assembly cushions and controls slow, smooth closing of the appliance door or access panel to reduce slamming and minimize wear. It restores damped movement and quieter operation for compatible LG units. What it does:

• Provides controlled, friction-based resistance for door/panel movement
• Cushions closing to reduce slamming and noise
• Helps prevent abrupt swings that can stress hinges or latches
• Restores even, predictable opening and closing motion

• Disconnect power to the appliance before starting any repair.
• Access may require removing an outer panel, trim, or door; follow OEM disassembly steps.
• Handle springs, tabs, and alignment carefully; ensure damper is seated and oriented as OEM specifies.
• Test operation after installation and reassemble panels securely.

This inlet hose directs household water into the washer so the machine can fill for wash cycles. It replaces a worn or damaged inlet connection to restore proper water flow and stop leaks. What it does

• Carries incoming water from the home supply to the washer's fill system.
• Stops leaks or drips caused by cracked or damaged inlet tubing.
• Helps restore normal filling when a damaged inlet restricts water flow.
• Works with factory inlet fittings and connections for a direct replacement.

• Turn off the washer and shut off the home's water supply before beginning work.
• Check and replace any rubber washers or O-rings at the connections if they are worn.
• Hand-start fittings, then tighten securely with a wrench — avoid over-tightening.
• After installation, run a short fill cycle and inspect all connections for leaks.

This sensor switch assembly restores the appliance's ability to detect position or operational signals so cycles start and controls respond correctly. Replaces a failed or intermittent sensing switch to address start, control, or sensor-related errors. What it does:

• Sends position/sensor signals to the control board so the appliance knows when a door, lid or component is closed or in the correct position
• Prevents operation when the appliance detects an unsafe or open condition (safety interlock behavior)
• Helps stop intermittent operation, no-start conditions, or control board error codes tied to a failed sensor switch
• Often used when a switch is unresponsive, physically broken, or has loose connector issues

• Always disconnect power before servicing the appliance to avoid shock or injury
• Match the connector orientation and secure any retaining clips or screws; do not force connectors
• Access may require removing an outer panel, door trim, or control housing
• After installation, restore power and verify door/sensor function and normal cycle operation; if you see persistent errors

This filter assembly is the appliance's line noise filter. It conditions incoming AC power and suppresses electrical interference to protect sensitive controls and help restore stable, reliable power when the original filter has failed. What it does:

• Suppresses EMI/RFI on the AC line to reduce electrical noise reaching the control system
• Helps stabilize power to boards, relays, and motors
• Common failure symptoms: no power, intermittent power, tripped breaker or blown line fuse, burning smell or visible scorching at the old filter
• Also known as a line filter, EMI filter, or noise filter

• 1 filter assembly

• Disconnect power to the appliance before servicing; capacitors in some products can retain a charge
• Note wire locations; transfer leads to identical terminals on the new filter and secure the ground connection
• Mount the assembly firmly in the original location to prevent vibration or wire strain
• After replacement, inspect related fuses and wiring if the old filter showed signs of overheating or surge damage

The Clamp is an OEM part for LG washing machines. It is used to secure the hose connections within the washer, ensuring that water flows correctly without leaks.

Over time, the clamp can become worn or damaged due to repeated exposure to water, vibration, or general wear and tear. If the clamp fails, it can lead to water leaks or hoses becoming detached.

Symptoms of a bad clamp include:

• Water leaking from hose connections
• Hoses coming loose or detaching during operation
• Visible rust or damage on the clamp
• Poor water flow or pressure issues

This OEM LG part is also compatible with Sears/Kenmore models.

The Affresh Washer Cleaner 3 Pack is an OEM cleaning accessory designed specifically for washing machines. This multipack contains 3 packets of a proven formula that helps eliminate odors from the washer tub, door, gasket, and drain areas. Regular cleaning is important to remove dirt, soap scum, mildew, and other residue that can build up over time and lead to odors. The Affresh tablets contain oxygen-powered enzymes and fresh scent boosters that are released during the cleaning cycle to safely and effectively eliminate musty smells.

This multipack of Green 4.2-ounce tablets ensures you have enough doses for consistent cleaning to keep your washer smelling fresh. As the #1 recommended washer cleaner brand, Affresh is also compatible for use in Maytag, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore washers.