Parts for Kitchenaid KSSC42QTS18: 13 - Top Grille And Unit Cover Parts

This Cover-Unit replaces the damaged or worn outer housing that protects the appliance's control area and wiring, restoring a clean appearance and protecting internal components from debris and accidental contact. What it does:

• Shields the control housing and wiring from spills, lint, and physical damage
• Restores the appliance's finished appearance where the original cover was cracked or broken
• Helps prevent exposed wiring and related safety concerns
• Can stop symptoms like loose or sagging control panels and visible internal parts

• One Cover-Unit housing

• Disconnect power (unplug or switch off breaker) before beginning any work
• Remove any control panel trim or screws as required to access and replace the cover
• Handle the cover and underlying wiring carefully to avoid connector or wire damage
• Use manufacturer service manual or OEM instructions for step-by-step guidance

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This replacement cover-unit restores the appliance's outer cabinet appearance and protects internal components from dust and debris. It provides a clean finished look and helps keep controls and wiring shielded from accidental contact. What it does

• Replaces a cracked, warped, or missing outer cabinet cover for a factory-fit appearance
• Shields control assemblies, wiring, and internal components from dust, spills, and physical damage
• Helps prevent debris from entering the appliance cavity and interfering with operation
• Restores the appliance's exterior cosmetics for improved resale value and user confidence

• Disconnect power (unplug or switch off circuit breaker) before starting any service
• Removal/installation typically requires removing exterior screws or clips; keep fasteners for reassembly
• Handle sharp edges carefully and avoid forcing the cover to prevent damage

This is a genuine replacement screw used to secure panels, brackets, and components on compatible Whirlpool appliances. It restores proper fastening so loose parts stop rattling and panels stay aligned. What it does

• Fastens trim, panels, brackets, or mounting hardware to appliance chassis
• Helps stop vibration and rattling caused by missing or stripped fasteners
• Restores secure connections after repair or part replacement
• Matches OEM thread specification to fit intended mounting holes

• Disconnect power to the appliance before beginning any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Start threads by hand and tighten until snug; do not overtighten
• Inspect mating threads and replace if damaged

Color: Stainless Steel