Parts for Kitchenaid KCMC1575BSS0: 02 - Turntable Parts

This round glass tray sits on the microwave's roller ring and engages the drive coupler. It provides a stable surface for dishes and rotates during cooking to help heat food more evenly.

• Supports food while cooking and reheating
• Engages the center hub to rotate with the turntable system
• Helps promote consistent, even heating when properly installed
• Replaces a cracked, chipped, or missing tray; can address wobbling when the original is damaged or not seated

• Unplug or disconnect power before servicing
• Position the roller ring correctly, then seat the new tray onto the center drive coupler so it sits flat
• Operate only with the tray fully seated and roller ring in place per your owner's manual

This Shaft-turn is the small rotating shaft used to transmit turning motion inside the appliance so the drive components rotate smoothly and reliably. It replaces a worn or damaged shaft to restore proper rotation and reduce noise. What it does:

• Transfers rotational force between drive components to enable normal spinning or turning
• Restores stable rotation when a worn shaft causes wobble or binding
• Reduces grinding, clicking, or unusual noise caused by a damaged shaft
• Helps prevent further wear to adjacent drive parts by providing a proper mounting surface

• One Shaft-turn

• Disconnect power (and gas, if applicable) before starting any repair
• Inspect surrounding components (bushings, bearings, clips) and replace as needed; only the shaft is included
• Use proper tools and follow appliance-specific disassembly steps; tighten any retaining fasteners to spec per OEM guidance

This foot base replaces a worn or damaged support that helps keep your appliance steady and level. Durable OEM-designed support restores stable footing and reduces wobble. What it does:

• Supports the appliance at the base to maintain stability during operation.
• Helps correct minor unevenness caused by a worn, cracked, or missing foot.
• Common replacement when the appliance rocks, vibrates, or does not sit level.

• Always disconnect power and any water or gas supply before servicing the appliance.
• Access the base area per your model's service manual or parts diagram before removing panels.
• Remove the old foot and install the replacement; hand-thread and adjust as needed to level the appliance.