Parts for Whirlpool WRT312CZJW00: Unit Parts

Size: 8-18 x 1/2 inch.

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

This is the replacement power cord that restores a safe, reliable electrical connection to your appliance. It supplies mains power so the unit can run without intermittent power loss or no-power issues. What it does:

• Provides the main AC connection from the wall outlet to the appliance
• Replaces damaged, frayed, or burned cords that can cause intermittent power or no-power symptoms
• Helps eliminate sparking or overheating at the plug or cord jacket when the existing cord is compromised
• Matches the OEM plug configuration to maintain proper fit and grounding

• One replacement power cord as shown

• Disconnect power at the breaker or unplug appliance before replacing the cord
• Verify cord routing and strain relief to avoid pinching or chafing during reassembly
• Do not use if the replacement cord shows visible damage — return or exchange for a new cord

This grommet is a small protective seal used where a hose, tube, wire, or component passes through or mounts to the appliance cabinet. It cushions the connection and helps prevent leaks, vibration, and wear for reliable operation.

• Provides a snug barrier between parts and metal openings to protect hoses, tubes, and wiring
• Helps seal against moisture to reduce seepage
• Dampens vibration and rattling noises
• Replace if cracked, hardened, missing, or no longer stays seated; symptoms may include drips at a pass-through, buzzing/rattling, or a loose fit

• Disconnect power; shut off water supply if applicable
• Access the grommet location and note orientation/routing
• Remove the old grommet and clean the opening
• Press the new grommet fully into place; reassemble and test for leaks/noise