Parts for Frigidaire CFU14M2HW2: 07 - System Parts

Freezer not cooling or leaking refrigerant? This external condenser coil replaces failed internal coils. Professional installation recommended.

Freezer not cooling below 32°F or water leaking under freezer? The drier filter removes moisture from the refrigerant system. Soldering required.

Replacement shelf support bracket for freezers. Secures and stabilizes freezer shelves. Replace if broken, cracked, or missing due to heavy loads or age.

Replacement shelf support clip for freezer shelves. Snaps into place to keep shelves level and secure. Needed when original clips are broken or cracked.

Replacement spacer for the front of the top grid in your freezer. Needed when original spacer is cracked, broken, or missing to properly support shelf.

Mounting screw that secures the top grid assembly inside your refrigerator. Replace if the original screw is stripped, missing, or damaged during maintenance.

Rubber mounting grommet that cushions and isolates the compressor from the chassis. Replace if cracked, worn, or missing to restore proper support.

Refrigerator not cooling or freezing? A failed compressor stops the cooling cycle. This sealed system repair requires a licensed technician to complete.

Freezer won't start or starts intermittently? This electrical relay assembly restores reliable power switching to get your freezer running again.

Compressor vibrating or loose? This mounting screw secures the compressor in freezers and refrigerators. Simple fix, basic tools required.

Freezer not cooling or freezing properly? This evaporator coil may be the issue. Professional installation required due to sealed system regulations.

Freezer not cooling or freezing properly? This evaporator coil may be the issue. Professional installation required due to sealed system regulations.

Freezer not cooling or freezing properly? This evaporator coil may be the issue. Professional installation required due to sealed system regulations.

Freezer not cooling or freezing properly? This evaporator coil may be the issue. Professional installation required due to sealed system regulations.

This retainer lead wire secures appliance wiring to keep harnesses organized and away from heat or moving parts, reducing wear and accidental disconnection. It's a simple replacement to restore proper wire routing and protection. What it does:

• Clips or holds the wiring harness in place to prevent chafing and strain
• Helps keep wires away from hot surfaces, vents, or moving components
• Reduces risk of intermittent electrical connections caused by loose wiring
• Restores factory routing after service or component replacement

• Disconnect power to the appliance before installing to avoid shock or injury
• Remove any panels necessary to access the original retainer and wiring route
• Replace like-for-like, seating the retainer securely so the harness cannot shift
• If wires show damage or insulation wear, inspect further and replace damaged wiring before reassembly

Secures freezer door hinge components in place. Replace if broken, loose, or causing door alignment issues. Verify fit with your model number.