Parts for Frigidaire PRT193MCH0: 02 - Door Parts

This wheat-colored electrical plug restores a secure connection in the appliance wiring harness, helping ensure reliable power delivery to components and reducing intermittent operation or loss of function. What it does:

• Provides a secure, color-coded connection point for wiring harness terminals.
• Holds and insulates mating terminals to prevent shorts and corrosion.
• Maintains continuity to the associated component so it runs reliably.
• Common symptom: component or circuit works intermittently or not at all when the plug or its terminals are loose or damaged.

• Always disconnect power to the appliance before inspecting or replacing electrical parts.
• Match plug orientation and fully seat the connector until it clicks; do not force.
• Inspect wiring and terminals for damage; replace any frayed wires or corroded terminals before installing.
• After installation, restore power and verify the affected component operates normally.

This outer freezer door panel in wheat restores the appliance's exterior finish and appearance. It replaces a faded, dented, or damaged outer panel to bring back a uniform look to the freezer door. What it does

• Replaces the freezer's outer door shell to repair dents, chips, cracks or cosmetic wear.
• Restores a consistent wheat-colored finish so the door matches the rest of the cabinet.
• Replaces damaged mounting tabs or warped surfaces that prevent a flush fit.
• Works with existing inner liner, insulation and door hardware to return the door's appearance.

• Basic door disassembly required: remove door from hinges and detach handle/trim before replacing the panel.
• Keep all original screws, clips and insulation; reuse OEM fasteners unless damaged.
• Wear gloves to avoid cuts from sheet metal edges and protect the finished surface.
• If the door alignment or seal is affected after installation, check hinge adjustment and gasket condition.

Right-hand door shelf support endcap for refrigerator door bins. Replaces broken, cracked, or missing supports that secure shelf bars to the door panel.

This part has been discontinued and is no longer available.

Left-hand door shelf end cap support secures refrigerator door shelves. Replace if cracked, broken, or missing to properly hold door bins in place.

Color: white. Measures about 2 inches high by 1-1/2 inches deep.

Replacement part may be longer than needed, per the manufacturer it will have to be cut to fit.

Replaces a cracked, broken, or worn door support bracket that holds and aligns your refrigerator door. Restores proper door fit and reduces sagging.

This part has been discontinued and is no longer available

This part has been discontinued and is no longer available.

Right-hand door shelf support endcap for refrigerator door bins. Replaces broken, cracked, or missing supports that secure shelf bars to the door panel.

Left-hand door shelf end cap support secures refrigerator door shelves. Replace if cracked, broken, or missing to properly hold door bins in place.

The Right Hand Door Shelf Support is an OEM part for Frigidaire refrigerators. This support bracket holds the door shelf in place, providing stability and ensuring that items stored in the door compartment remain secure.

Causes of a bad door shelf support can include wear and tear from regular use, physical damage from overloading the shelf, or breakage due to impact when opening or closing the door. Over time, the plastic material can also become brittle and crack.

Symptoms of a bad door shelf support include:

• Door shelf sagging or detaching from the door
• Difficulty in securing items on the shelf
• Visible cracks or damage to the support bracket
• Items falling out when opening the door

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Left side door shelf support. Color: White. Measures about 1 3/4 inch x 1 3/4 inch. For the right hand side order 3206150.

This part has been discontinued and is no longer available.

Replace your cracked or broken refrigerator door shelf. This bin installs directly on the door to hold condiments and beverages. Order now if damaged.

The Refrigerator Door Gasket is an OEM part for Frigidaire refrigerators. This gasket forms a seal around the refrigerator door, ensuring that cold air stays inside and warm air remains outside, maintaining the appliance's efficiency and keeping food fresh.The gasket measures approximately 44.6" X 30.69"

Causes of a bad door gasket can include regular wear and tear, mold or mildew buildup, and physical damage from repeated opening and closing of the door. 

Symptoms of a bad refrigerator door gasket include:

• Warm air entering the refrigerator, causing it to run more frequently
• Condensation or frost buildup inside the refrigerator
• Difficulty keeping the door closed
• Visible cracks, tears, or deformation in the gasket

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Replacement mounting screw for refrigerator components and panels. Secures interior parts, shelves, or housing. Order when original is stripped, lost, or damaged.

Secures refrigerator door handle to door panel. Replace if screw is stripped, corroded, missing, or if handle has become loose or wobbly over time.