Parts for Frigidaire WRT21BGED0: 02 - Door Parts

The Refrigerator Door Gasket is an OEM part for Frigidaire refrigerators. This gasket forms a seal around the refrigerator door, ensuring that cold air stays inside and warm air remains outside, maintaining the appliance's efficiency and keeping food fresh.The gasket measures approximately 44.6" X 30.69"

Causes of a bad door gasket can include regular wear and tear, mold or mildew buildup, and physical damage from repeated opening and closing of the door. 

Symptoms of a bad refrigerator door gasket include:

• Warm air entering the refrigerator, causing it to run more frequently
• Condensation or frost buildup inside the refrigerator
• Difficulty keeping the door closed
• Visible cracks, tears, or deformation in the gasket

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This replacement butter dish restores a clean, secure storage area for butter and small spreads in the refrigerator door. It keeps butter contained and helps prevent odors and spills for everyday use. What it does:

• Replaces a cracked, broken, or missing butter dish in the refrigerator door dairy compartment
• Holds a stick or small portions of butter and keeps them from contacting other foods
• Helps contain crumbs and minor spills for easier cleaning of the door shelf
• Provides a neat, designated spot for butter to improve organization

• One butter dish

• No special tools required; remove the old dish from the door shelf and snap or slide the new one into place
• Clean the door shelf area before installing to ensure a secure fit
• Handle carefully to avoid chipping the plastic during installation
• If the dish doesn't seat easily, verify it is aligned with the door shelf guides before forcing

This replacement screw secures appliance components so brackets, shelves, trim, or panels stay firmly in place. Install a new screw when the original is missing, stripped, or corroded to restore a tight, rattle-free fit.

• Fastens brackets, panels, trim, or covers to the cabinet or liner
• Helps maintain alignment and reduce vibration and noise
• Direct replacement for a missing, rusted, or stripped fastener
• Use wherever your model's parts diagram specifies this screw

• Disconnect power before servicing; shut off water if working near water lines
• Match thread and length to the original location as shown in your model's parts diagram
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening (especially into plastic)
• Retain and transfer any original spacers or clips used with this fastener

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.