Parts for Frigidaire WAL123Y1A3: 05 - Compressor Parts

Replace worn compressor mounting grommets to stop excessive vibration and noise. Fits most air conditioner and heat pump models. Simple DIY fix.

This overload protector helps prevent compressor overheating by interrupting power when the compressor draws too much current, protecting the appliance and helping extend compressor life. Installs inline with the compressor start components. What it does:

• Senses excessive compressor current/temperature and cuts power to stop overheating
• Works together with the start relay to allow safe compressor startup
• Helps prevent compressor damage that can result from electrical overloads
• Commonly replaced when the compressor clicks off, hums but won't start, or the fridge stops cooling

• Disconnect power to the appliance before accessing or servicing the compressor circuit
• Typically mounted on or near the compressor; may require removing a rear access panel
• Handle compressor terminals and wiring carefully; match terminal orientation and seating

Fix an AC compressor that won't start or struggles to turn on with this start assist kit. Helps older units start reliably. DIY-friendly installation.

Fix water leaks and overflow under your air conditioner with a new evaporator drain tray. Prevents water damage and improves drainage. DIY-friendly repair.

Refrigerator not cooling properly? This 45-inch capillary tube regulates refrigerant flow in the cooling system. Cut-to-length design for custom fit.

Vacuum strainer filter captures debris and protects the motor. Replace when clogged or damaged to maintain suction power. Verify fit with your model.