Parts for Amana AUF170KW / P1317706W W: 03 - Machine Compartment And System Parts

Fix frost buildup and warm temps in your freezer with a new defrost timer. Restores automatic defrost cycles. Straightforward DIY repair.

Fix poor drying performance with this dryer drier filter assembly. Restores proper airflow and prevents overheating. Standard DIY repair.

Refrigerator not cooling or running too warm? A failed compressor stops refrigerant circulation. This is an advanced repair requiring special tools.

Replacement mounting screw for securing panels, brackets, and components inside your appliance. Needed when original screws are stripped, lost, or damaged.

Secures covers, brackets, and internal panels in your refrigerator. Replace missing, stripped, or corroded screws to restore tight mounting.

Fix ice buildup in your freezer with this defrost heater. Replaces burnt-out heating elements on evaporator coils. Moderately difficult, 2-5 hour repair.

Fix a freezer that won't cool or has frost buildup with this evaporator coil. Requires soldering skills and heat shield for installation.

Fix ice buildup and cooling issues with a new defrost thermostat. This bi-metal switch monitors evaporator temperature to prevent frost accumulation.

Protective shield that covers and guards the motor assembly in your freezer. Replace if the original is cracked, broken, or missing to protect components.

Motor mounting bracket for freezers. Secures the motor assembly in place. Replace if cracked, broken, or causing motor misalignment or vibration.

This overload is a thermal protection device that mounts on the motor/compressor and opens the circuit when excessive heat or current is detected. Replacing a weak or failed overload helps restore safe startup and protects the windings from damage. What it does:

• Monitors motor/compressor temperature and current draw
• Interrupts power on overheat/overload to prevent damage
• Aids troubleshooting of start/run issues when paired with the start device
• Common symptoms: hums then clicks off, won't start, intermittent shutdown, frequent tripping

• 1 thermal overload protector

• Disconnect power before servicing; allow components to cool
• Access the terminal area on the motor/compressor; remove any cover
• Note/photograph wire positions; transfer wires and fully seat the new overload on the correct terminal
• Inspect the start relay, capacitor, and terminals for heat damage; replace any compromised parts

Secures the terminal cover on your refrigerator's compressor. Replace if damaged, loose, or missing to ensure safe electrical connections. Verify fit.

This sleeve grommet installs on your dehumidifier to protect wiring or tubing from sharp edges. Replace if cracked, worn, or missing to prevent damage.

Replacement mounting screw for freezers and refrigerators. Secures internal components and panels. Order a new screw if original is stripped or missing.

Loose panels or rattling components? This mounting screw secures body panels and electronics in appliances. Quick 5-minute fix for most models.