Dick for Model Number Kenmore 665.15954000 Thanks for feedback. Here's more detail. Dishwasher starts the longer cycles (Anti-Bac, Pots & pans and Normal) but stalls out after about 15-20 minutes. Machine keeps running (circulating water in the tub) but will not go beyond that point (84 min, 82 min and 76 min). It also skips some minutes on the way down. So it is not really running for the full 15-20 minutes. Water in tub is hot, but probably not hotter than input water. Sensor light is also on when it stalls out. For shorter cycle (Time Saver), there is no problem. Suggestions?
Answer Hi. Run the sink water and verify you have at least 120° incoming water temperature. Open the inner door to access the tech sheet. It is usually under the control panel or in behind the kick plate. It will show the circuit of the Thermistor part # WP8269208. Disconnect it from the control board and ohm out the circuit for. It should read 48-52k at room temperature, and 12-13k at 140°. Use a volt/ohm meter part # MA-DM1 to assist you in your diagnostics. Thank You. Read More... Answered by AppliancePartsPros.com | Tuesday, November 27, 2012