Todd for Model Number ATF6000ES1 My Frigidaire Affinity front load washer (ATF6000ES1) has no problem with draining and doing a final high speed spin for all the cycles EXCEPT the Spin Only cycle. Every once in a while, on a heavy load or load that the washer is unable to balance for spin, the washer will finally give up without high speed spin. My wife then tries the Spin Only cycle. The washer goes through the drain portion of the cycle, slowly rotates the load in alternating directions 7 times (I think), and then totally shuts down (all lights off) at 6 min remaining without attempting any sort of high speed spin. This happens with a load or empty. Holding the Cancel and Start buttons shows a E47 code. I checked the Door Latch assembly PTC and it showed about 1600 Ohms so it should be OK. Next step per the Washer Tech Data Sheet is to replace the Main Control Board. Does my problem sound like it should be solved doing this? Thanks!
Answer Hello Todd, Since the fault code indicates the board thinks the door PTC circuit is open in spin and the unit will go through the spin cycle in the cycles, the board 134523106 has to have an issue. Read More... Answered by AppliancePartsPros.com | Tuesday, January 13, 2015