Customer Questions and Answers for Washer Drive Motor by Frigidaire

Hi Danny. Remove the back panel and find the wiring diagram. Use the same size pressure switch hose to blow into the pressure switch when it is full on a small load. If the washer agitates now then you need a pressure switch part # 134421000.You can also jump the #1 and #3 pressure switch wires together momentarily and tape them for safety. This will resolve a bad pressure switch. Blow into the hose going down into the tub. Did you feel any restriction being removed ? If so reconnect the hose and advance the full tub into a spin to reset the pressure switch. Use washer magic monthly part # TJ131 to insure proper performance. Lift the top, re4move the front panel. Jumper the lid switch 2- wires, if it agitates now then replace the lid switch part # 134101800. Use a volt/ohm meter part # MA-DM1 to assist you in your diagnostics. Then lift the top tub cover off and remove the agitator. Remove the inner tub. The inner tub mount is called a trunnion part # 131545101. It has 2-large bolts part # 137539500 holding a flat plate part # 137107000 . What happens at times one bolt will break and the flat bar cannot place the inner tub properly onto the flat notch on the side of the agitator shaft, thus no agitation. Thank You.