Customer Questions and Answers for Switch Harness Assembly (Surface Burner Ignition) by Ge

This switch harness assembly links the cooktop burner knob switches to the ignition circuit so the burners spark when you turn a knob. Replacing a damaged harness restores consistent lighting and can stop intermittent or continuous clicking during use.

• Routes electrical signals from the surface burner switches to the spark module
• Triggers igniters to click when a knob is turned to Lite
• Typical symptoms: no spark on any burner, constant clicking, or sporadic ignition
• Physical clues: heat-damaged insulation, broken connectors, or moisture intrusion

• Disconnect electrical power and shut off gas before servicing.
• Access location varies by model; remove knobs and lift the cooktop or front panel to reach the harness.
• Label or photograph wire routing; transfer connectors one at a time to avoid miswiring.
• Route wires away from sharp edges and hot surfaces; reassemble, restore power, and test each burner.