Murray for Model Number LG WM1832CW I was having increasingly frequent spin problems until one day a loud grinding noise came from the rear of the machine. I removed the access cover and discovered the spline on the nylon hub of the Rotor assy was stripped. I ordered a new Rotor Assy and Hall sensor. Received the parts, installed them, however now I have Rotor lock. I've checked the resistance of the Stator, it appears to be within specs. Ive checked the power connection to the Stator, and there is voltage , however Im not sure of the correct values. I've removed and re-assembled the new components a couple of times, but I still get rotor lock. I've turned the drum by hand, so I know its not seized. Do you have any suggestions. Thank you for your time.
Answer Murray, If getting an LE error code you will want to check the flowing. • The connector (3-pin, male, white) in the MOTOR HARNESS is not connected to the connector (3-pin, female, white) of STATOR ASSEMBLY. • The electric contact between the connectors (3-pin, male, white) in the MOTOR HARNESS and 4-pin, female, white connector in the MAIN PWB ASSEMBLY is bad or unstable. • The MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited). • The hall sensor is out of order/defective Read More... Answered by AppliancePartsPros.com | Friday, October 3, 2014