Andy for Model Number maytag centenial washer model mvwc300xw Machine runs through cycle up to spin and then then door latch light and the spin cycle light flash non stop and it will not restart. I turn the control to spin/drain and restart but it will only spin occasionally. It does not completely spin and the laundry is still wet. It's like the machine is not removing all the water even though the pump seems to be working fine and is not blocked. Does the circuit board need replacing or is there a simple solution? Thanks
Answer Hello Andy, This is most likely caused by the harness WPW10297440, the actuator WPW10006355, the control W10438123, or the motor WPW10303798. It is probably a good idea to pull the spin basket before ordering a lot of parts to make sure there are no items between the tubs causing the issue. You should also pull the fault codes as laid out in the tech sheet. This will be located in a zip-lock bag glued to the inside of the front panel. Be sure to put it back and reseal the bag so it can be located if needed again. Read More... Answered by AppliancePartsPros.com | Wednesday, February 26, 2014