Handymanray for Model Number GHW9400PT4 Whirlpool Duet Washer I repeatedly get the F06 error code. The washer will run a few minutes into a cycle then stop. I have performed the continuity test on the motor and get a reading of 6 ohms on each pair of pins checked. Washer runs Diagnostic Test as described on data sheet with no problems. However, slightest load in basket causes it to stop and give error code. Please help - is this a bad MCU or is drive motor bad even though it tests as noted above?
Answer Hello Handymanray. If the motor is testing good, and the wiring harness is good, then it sounds like the MCU W10756692 is bad and will need to be replaced. Hope this helps. Read More... Answered by AppliancePartsPros.com | Thursday, November 17, 2011