George for Model Number LAT4910AAL After I replace the Lid Switch Assembly my Washer start to make a bad squeaking sound while agitating. If it a bad drive belt, tell me how to get to that area in order to replace it.
Answer Hi George. There belts are underneath the unit. There are 2 of them. Belt kit part # 12112425. There are 2 lower Philips screws in the front panel Remove these and pull the bottom half out towards yourself. This will release the panel top clips. You need to inspect the pump to see if something is inside it. Pump part # WP6-2022030.You can pull out the unit and tilt it back while supporting it. Then you can inspect the belts, pulleys and the brake system. Rotate the main pulley one way and it will lift the internal brake spring to lift the brake, this will spin the inner basket freely. If it does not , then you may have a broken brake assy. You can rotate the opposite direction and it will allow the transmission to agitate. Clean the pulleys with paper towels and rubbing alcohol to clean for new belts. Thank You. Read More... Answered by AppliancePartsPros.com | Tuesday, December 27, 2011