William A310 Washer. Where do these two belts go? I can not visually find them with the front cover off. Do I need to remove the rear cover? Do I need to remove a component inside the washer? Thanx. Can you provide a picture?
Answer Both the pump and the drive belts go underneath the washer. Very simple to replace, no need to remove the front panel. Simply tip the washer back at about 45 degrees (first make sure the washer is empty of water). Don't lay it flat on its back, it may ruin the transmission. You'll see the pump pulley, the motor pulley, and the big drive pulley. Here is a diagram: http://www.appliancepartspros.com/partsearch/model.aspx?model_id=28786&diagram_id=28323430#d28323430 . I would recommend replacing both belts at once - 12112425. Read More... Answered by AppliancePartsPros.com | Thursday, February 17, 2011