Timothy B West Plains , MO May 28, 2018 Appliance: Whirlpool Electric Dryer GEW9250PW0 Stopped heating Quick check with ohm meter showed that the hi-temp limit switch was open. Verified my thoughts were correct with you tube videos. Quickly received parts from appliance parts pros and repaired dryer in 15 minutes. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers, Socket Set
Walter H Palm Bay , FL May 26, 2018 No heating. Replaced the heating element and the thermal switches. The dryer works like new. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers
Jeff T Highlands , NC May 13, 2018 Appliance: Model WHIRLPOOL 9250 Our 13 year old Whirlpool duet dryer stopped drying. I have in the past replaced the heating element so I figured it might be the thermo coupler removing the front lower panel took a minute. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Gerald D Penn Valley , CA May 04, 2018 Heater died Bought new element. Followed the you tube video for easy replacement. Good tip getting the dryer front off with putty knife to release. The parts were in the kit and easily identified. Watch out for sharp edges on the crudely stamped and cut out parts. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Robert S Sharpsburg , GA April 21, 2018 Appliance: Whirlpool Electric Dryer GEW9250PL0 Dryer was not getting hot blowing cool air only Replaced the thermal fuse and thermostat. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Don W Garnavillo , IA April 15, 2018 Appliance: Whirlpool Dryer GEW9200LW0 Thermal switch dryer was not heating Upon inspection the heating element looked good it was replaced five months ago I didn't have a meter to test so used process elimination and research to determine what was wrong the next thing in line was thermal switches so ordered thermal cut off kit. When thermal cut off kit arrived I installed and dryer is now working again and the wife is happy! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Socket Set
Cornelius P Sumrall , MS March 30, 2018 Appliance: Model 110.87729700 The dryer was not heating it was running but no heat was produced Replaced the heating elements and one of the sensors. The online videos were very good. There were a few little differences, but you can't put a video up for every sub model. The videos helped with my repair a lot. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set
Tammy S Connellsville , PA March 24, 2018 Heating Heating element Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Socket Set
Stephen V Tampa , FL March 23, 2018 Appliance: Model DUET DRYER Heat stopped working on my dryer Watched a video on checking the coil and thermostats. I already had an analog continuity tester and used it to find the bad part. I ordered it from the website. It arrived a couple days later. Easy to replace. Total cost around $30. So much better than $1000 for a new one. About an hour’s work including cleaning out 10 years of lint! Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Socket Set
Cherrita G Cumming , GA March 07, 2018 Dryer not heating Replace element and thermal cut off kit. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers, Socket Set