First of all I fabricated a center post bearing puller and move the two exiting bearings midway to center of the tube with the existing seals and install the new bearings and seals as indicated from the drawing when I purchased the bearing & seal kit on my first order. Secondly, I ordered the brake pads, and last, I ordered the tub seal, tub suspension pads, suspension pad kit and the washer drive block. Then I replace the brake pads, tub seal, two sets of pads and washer drive block in one time disassembly and re-assembly of my washer. So far the vibrating noises and strong shaking motion went away when I tested the washer at full load four times. In my opinion the washer drive block was the culprit because it was easy to remove the existing drive block when I was disassembling the washer and when I was putting the new drive block it was tight putting it into the right position within the two setting notches of the shaft. I was very satisfied of the result putting all the parts I had ordered and was exact replacement from AppliancePartsPros.com. I will give them FIVE STAR*****.