Parts for Hot Point RB525DH1BB: Door & Drawer Parts

10-32 machine screw secures panels, brackets, door hinges, and handles in ovens and ranges. Replace missing, stripped, or broken screws for tight fit.

Replace your worn, bent, or warped oven rack. Provides a stable surface for baking sheets and pans inside your range oven. Fits standard ovens.

Panel mounting screw secures trim, bezels, and internal components on ranges and cooktops. Replace when stripped, corroded, or missing to restore fit.

Replacement door hinge assembly for electric ranges. Mounts between door and body to support proper door alignment. Order when hinge is cracked or bent.

Metal pan that forms your range's lower drawer assembly. Replace if bent, rusted, or damaged to restore proper alignment and smooth sliding on tracks.

Hardware washer kit for various appliances. Includes 12 washers for securing components during installation or repair. Replace worn or missing washers.

Seals your oven door to retain heat and maintain proper cooking temperature. Replace if torn, brittle, or heat escapes. Clips into place in minutes.

Maintains proper gap between range components for secure mounting. Replace if worn, missing, or cracked to prevent panel rubbing and ensure correct alignment.

Inner foam pad that fills the range oven door cavity for thermal insulation. Replace when cracked, compressed, or missing to restore door performance.

Replace a worn, cracked, or missing handle grommet on your electric range. Secures and cushions the handle mounting to prevent rattles and restore a snug fit.

Mounting screw for range installation and assembly. Replace missing, stripped, or damaged screws to secure panels, brackets, or components properly.

Control panel door for electric and gas ranges. Replaces cracked, broken, or missing door covering the control area. Direct fit cosmetic component.

Right-side drawer glide supports and guides your range's lower drawer for smooth operation. Replace if broken, cracked, or worn to restore alignment.

Plastic support guide that mounts to the rear of your range storage drawer. Replace if cracked, broken, or missing to keep drawer aligned and gliding smoothly.

Secures the lower storage or warming drawer to your range cabinet. Replace this bracket if it's bent, broken, or missing to restore proper alignment.

If your oven isn't maintaining temperature or has poor heat distribution, this barrier door assembly restores proper sealing and airflow control.

This retainer secures wire insulation and small wiring bundles to the appliance chassis to prevent chafing and maintain safe routing. It's a simple replacement that helps keep wiring organized and protected from heat or abrasion. What it does:

• Holds wire insulation and small harnesses in place to prevent rubbing and wear
• Helps maintain correct wire routing behind panels and near heating elements
• Reduces risk of electrical shorts caused by damaged insulation
• Commonly used where a small clip is needed to anchor wiring to the cabinet

• One retainer for wire insulation

• Disconnect power to the appliance before starting any repair
• Access panel removal may be required to reach the retainer location
• Fasten the retainer by snapping or sliding it into the matching slot or hole; replace only with the same style to ensure proper fit
• If wiring shows damage, replace or repair wiring before reassembly

Replaces the front panel of your range drawer when cracked, dented, scratched, or faded. Restores finished appearance and covers drawer opening.

Replacement mounting screw for appliances. Secures components and reduces vibration. Needed when original screws are missing, stripped, or damaged.