Parts for Ge ZDIC150WBBD: 02 - Evaporator, Ice Cutter Grid & Water Parts

This is a GE water inlet valve designed for certain refrigerator ice makers. The water inlet valve is responsible for allowing water from the inlet line into the icemaker, but also for preventing water from flowing when ice is not needed. Over time and through normal use, the valve will suffer from wear and tear and will eventually need to be replaced.When the valve fails, the water line will need to be turned off to prevent further leaks. A replacement will be necessary before the icemaker can be used again. Replacing the water inlet valve will require locating the old one within the icemaker, detaching the water lines, and uninstalling the valve assembly from the appliance.This genuine OEM part is sold individually. It is compatible with several different GE refrigerator models.

This pushnut fastener secures shafts, studs, and small components by snapping into place for a reliable hold without threads. It's a simple replacement part that restores proper retention for panels, knobs, or internal linkages. What it does:

• Grips and locks onto a shaft or stud to prevent axial movement
• Holds small panels, trim, or linkages in place where a threaded fastener isn't used
• Helps stop rattles and intermittent disengagement caused by a worn or missing retainer
• Works where a quick, tool-friendly installation is preferred

• One pushnut fastener (quantity: 1)

• Push onto a clean, undamaged shaft or stud until fully seated; do not hammer on delicate components
• Inspect mating shaft/stud for burrs or damage—replace if necessary to ensure secure fit
• Wear eye protection; small parts can snap off or eject during installation
• If removal is required, use a thin pry tool or pick to avoid distorting the retainer

This cover grid is a factory-design trim panel that protects and finishes the refrigerator interior where airflow or components pass through. It restores proper fit and appearance and helps keep internal components covered. What it does:

• Covers and protects internal openings to prevent debris from reaching components
• Restores finished appearance to the refrigerator interior after damage or removal
• Helps maintain proper airflow routing by keeping openings trimmed and aligned
• Reduces rattles or vibration caused by a loose or broken trim piece

• One cover grid trim panel

• Install with manufacturer-recommended fasteners; verify alignment before tightening
• Power off and unplug the appliance before accessing internal areas
• Handle gently to avoid snapping plastic tabs; replace any broken clips
• Replace any missing or damaged trim or mounting hardware for secure fit