Parts for Ge ZDIC150WSSA: 02 - Evaporator, Ice Cutter Grid & Water Parts

This genuine replacement part is a water valve for refrigerator ice makers. The water valve supplies water to the ice maker to fill the water reservoir. If the icemaker is no longer operating properly and no longer dispensing ice, it might mean that the water valve needs to be replaced. Thankfully, replacing this part is an easy repair. To begin, make sure all the power is turned off to the appliance. Open the freezer door where the water dispenser is located. Remove the inner panel of the door by unfastening the screws that secure it. Once the panel has been removed locate the old water valve and release it from its mounting brackets. Once removed, replace with the new water valve. Reinstall the door panel and restore power to the refrigerator. This OEM part is compatible with General Electric, Hotpoint, and RCA brand refrigerators.

Nut for 1/4 inch tubing.

This refrigerator water line is the plastic tubing that routes pressurized water through the appliance's water system. Replacing a cracked, brittle, or kinked line helps restore proper water flow and prevents leaks inside or around the unit.

• Carries water between the inlet valve and the refrigerator's water system components
• Helps maintain a sealed path for reliable flow to the dispenser and/or ice maker
• Replace if tubing is cracked, kinked, brittle, or leaking
• Common symptoms include puddling, dripping, reduced/No water at the dispenser, or ice maker not filling

• Disconnect power and shut off the water supply before servicing
• Note the original routing and clip locations; avoid sharp bends and kinks during installation
• Fully seat tubing into existing connectors/fittings on your model
• Turn water back on, check all connections for leaks, and purge air by dispensing water

This cover grid is a factory-design trim panel that protects and finishes the refrigerator interior where airflow or components pass through. It restores proper fit and appearance and helps keep internal components covered. What it does:

• Covers and protects internal openings to prevent debris from reaching components
• Restores finished appearance to the refrigerator interior after damage or removal
• Helps maintain proper airflow routing by keeping openings trimmed and aligned
• Reduces rattles or vibration caused by a loose or broken trim piece

• One cover grid trim panel

• Install with manufacturer-recommended fasteners; verify alignment before tightening
• Power off and unplug the appliance before accessing internal areas
• Handle gently to avoid snapping plastic tabs; replace any broken clips
• Replace any missing or damaged trim or mounting hardware for secure fit