Search Results

• Will not drain

Unscrewed the leaking filter and replaced with the new one. End of problem. Great service and prices at Appliance Parts Pros.com. This will be the first place I check whenever I need repair parts for any of our appliances in the future. Read more

Ordered new filter. Easy order , and part was delivered next day. What great service!!! Read more

Easy! Took the old case filter off and put the new case filter on. Two clicks and it was done! I would also like to say how great it was to deal with this company, easy ordering, best price, and fast delivery. Keep up the great work. Read more

As a Mechanic, I did the common sense approach: INITIAL OBSERVATIONS & CHECKS: - Unplug Machine & check inlet water hose connections for leaks and signs of hose failure; - Remove back panel & inspect for water presence at all hose connections, pump, bottom of basket (bottom center of basket where the main motor, shaft bearing, and tub seal is located), dispensers, bottom of wash basket, water injector area, look everywhere where there is a hose connection and where water flows... - Inspect... Read more

Had to purchase a new filter as the felt does not feed back into the ridge in the filter. It seems to me that the felt should not pull out so easily. My dryer isn't even a year old so I think this is a design failure. But the new filter works great and hopefully we won't have this problem again. Thank you for your prompt service! Read more

I referenced the repair video. Very straightforward and easy. Only need 3 tools: 1/4 and 5/16 nut drivers and Philips head screwdriver. About 15 minute job. Surprising how much lint and dust build up inside the chassis, was able to clean that out too. Read more

Tried cleaning them with bristled brush but just wasn't cutting it. Replaced with new. Hoping for cleaner dishes. Read more

I replaced the filter cartridge that is located underneath the lower spray arm. The original filter cartridge had become completely blinded off, the filter media is a very fine mesh nylon fabric and it gets clogged up eventually with hard water scale and other non-soluble materials (including dishwasher detergent). When this filter gets plugged, too little water flows through to the pump to be recirculated during washing. Replacement is relatively easy, except for the awkward position of... Read more

First I verified there was good water volume getting to the door, by uncoupling the hose at the door bottom (press in coupler ring) and activating the dispenser, there was not. (have a cup ready) Since the water filter is inline, and I had another I subbed it. Still no change. Here I made an error. I verified the water supply was fine, so jumped to the conclusion it had to be the solenoid operated valve, which it was not. I did not realize that the water filter bracket it attaches to has it's... Read more

When Microwaving food, the display panel would seem to act normal, but the typical microwave sound would be absent. No microwave action would occur. Eventually an F5 code would display. Problem was the upper door switch. Found it by opening up the cabinet, removing the display panel (1 screw and a couple of plugs) and testing all three micro switched with a meter. Two switches are for the door and one for some kind of ventilation flap. They are all in the same area. Go to YouTube to see... Read more

I replaced both of these parts and the dryer is heating now. Thanks AppliancePartsPros.com! Read more

We were experiencing slow water flow from our Whirlpool interior water dispenser. The water would flow normally for a couple of seconds then subside to a trickle. After replacing the water filter and inlet valve, research suggested that the water filter head could be the culprit. In about 30 minutes, I was able to remove the old part and replace with a new part solving the problem. Read more

Just wanted to say how incredibly nice and helpful the gentleman was that helped me on the phone when I called to place the order. Very nice..... Read more

I had previously replaced the pump about 1 year ago. That was not the problem. Still leaked the same way - intermittently, but always in the center of the washer onto the floor. None of the hoses were leaking - no evidence of corrosion or water mineral residue at any of the hose fittings. So, it must have been something else. I studied the parts diagram for the washer tub assembly and concluded the source of the leak almost had to be the outer tub's Centerpost Gasket. It was really the... Read more

• Takes too long to dry

Sent an e-mail to AppliancePartsPros.com to make sure the filter I was ordering would fit my dryer model. Upon receipt, I simply replaced it. Read more

Removed micro=filter and replaced it Read more