Parts for Ge GTS17GTNHRWW: Fresh Food Section Parts

Fix warm refrigerator temperatures and frost buildup with this door gasket foam seal strip. Restores cushion for a tighter seal. Easy 15-minute install.

Leveling leg threads into the refrigerator base to support and stabilize the cabinet. Replace if cracked, broken, or worn to keep your unit level.

Top hinge and pin assembly supports refrigerator door weight and provides pivot point for smooth operation. Replace when door sags or won't seal properly.

Replace your refrigerator's center door hinge to restore smooth door movement and maintain a proper seal. Supports door weight at the pivot point. Confirm fit with your model number before ordering.

Pivot shaft for refrigerator doors at the middle hinge. Replace if worn or bent to restore proper door alignment and smooth operation. Verify fit.

White plastic corner cap that snaps onto refrigerator door corners to conceal fasteners and protect hinge areas. Replace if cracked, broken, or missing.

Small washer that fits on refrigerator door hinges to distribute weight and reduce friction. Replace if worn, cracked, or missing to restore proper alignment.

Supports the refrigerator door at the lower pivot point for smooth opening and proper sealing. Replace if the door sags or won't close tightly. Confirm fit by model number.

Bottom hinge pin secures the refrigerator door at the base, allowing smooth opening and closing. Replace if worn, damaged, missing, or door sags.

A replacement foam supply nozzle that directs detergent/soap flow into the wash chamber to help ensure proper dispensing and reduce excess suds. Fits select top-load and front-load washer dispenser assemblies. What it does:

• Channels detergent/soap from the dispenser into the wash tub for even distribution
• Helps prevent soap from pooling or over-foaming during the fill cycle
• Commonly replaces cracked, clogged, or warped nozzles that cause poor dispensing
• Can resolve symptoms like detergent leaking from the dispenser, excess suds, or uneven cleaning

• One foam supply nozzle

• Disconnect power (and water, if applicable) before beginning any repairs
• Remove dispenser assembly per manufacturer instructions; replace nozzle and reassemble carefully
• Inspect surrounding seals and clips and replace if damaged to prevent leaks

Replace a cracked or broken control housing on your top-mount refrigerator. This part secures buttons, knobs, and control boards for proper alignment.

This control shield is a replacement console protector that helps shield the oven/range control assembly from heat, splashes and debris to keep the control area working cleanly. It restores the protective barrier behind the front control surface. What it does:

• Protects the control board and front console from heat, grease and food splatter
• Helps prevent damage that can cause intermittent or unresponsive controls
• Restores proper spacing and support behind the control panel
• Used when the original shield is warped, cracked or missing

• One control shield

• Disconnect power (unplug or switch off breaker) before starting any repair
• Remove the control panel or console trim per service instructions to access the shield
• Replace with matching orientation and secure using the original screws/clips; do not force or bend the part

Fix interior lights that won't turn on, stay on constantly, or delay when opening the door. This switch replacement takes 10-15 minutes with basic tools.

Replacement mounting screw for refrigerator panels, brackets, and covers. Needed when original screw is missing, stripped, or damaged during service work.