Parts for Ge AZ95E18DACK1: Motor & Chassis Parts

This is a 5/16" shoulder screw used to secure components where a stepped or "high-low" shoulder is required, restoring proper alignment and function for the mating parts. It provides a precise spacing/registration point. What it does:

• Secures panels or internal components while maintaining a set shoulder spacing
• Replaces worn or missing shoulder screws that cause misalignment, rattling, or loose fittings
• Used where a screw head and reduced shaft create a built-in standoff
• Typical use in appliance assemblies that require a registered fit between parts

• Recommended for experienced DIYers; verify orientation and shoulder placement before tightening
• Use the correct driver and avoid over-torquing to prevent stripping or damage
• Disconnect power to the appliance and follow manufacturer safety procedures before servicing

This silicon controlled rectifier (SCR) regulates high/low power output in the appliance's control circuit to help the heater or motor receive the correct voltage during operation. Replacing a faulty SCR restores proper power switching and control. What it does:

• Controls high/low voltage output to the heating or motor circuit for staged power delivery
• Helps maintain correct power switching during heat or motor cycles
• Commonly linked to symptoms like weak or no heating, intermittent operation, or failure to switch between high/low modes
• Works as a direct replacement component in the appliance's power-control assembly

• One silicon controlled rectifier (SCR) unit

• Turn off and unplug the appliance (or switch off circuit breaker) before servicing
• Handle electronic components carefully to avoid static damage; use anti-static precautions if available
• Verify wiring and mounting location match the original part; secure connectors fully