Kenmore Washer 110.22082101 (11022082101, 110 22082101) Parts

This water level switch monitors the washer's water height and tells the control when to stop filling. Replacing a faulty switch restores reliable fill control and helps prevent overfilling or improper wash cycles. What it does:

• Detects water level via air pressure from the tub and signals the control board to start/stop filling
• Stops filling when the correct water level is reached to prevent overfilling
• Can cause no-fill, overfill, or erratic water levels when failing
• May prevent the washer from advancing through cycles if the control does not receive a correct level signal

• One water level switch assembly

• Disconnect power before starting any repair to avoid shock or injury
• Turn off water supply and remove panels as needed for access
• Handle electrical connectors and the pressure hose carefully; ensure the hose is seated and not kinked
• Test the machine through a short cycle after installation to verify correct water-level operation

This is a single OEM replacement screw used to secure panels and components on compatible appliances. It restores proper fit and prevents loose or vibrating parts for a safer, more reliable repair. What it does

• Secures panels, brackets, and small components in appliance assemblies
• Restores proper alignment and fit when original screw is missing or damaged
• Prevents rattling, vibration noise, and parts shifting during operation
• Works where the OEM specifies this exact screw size and thread

• One replacement screw

• Unplug the appliance or shut off power before servicing
• Use the matching driver and avoid over-tightening to prevent stripping threads
• Verify correct screw length and thread engagement for the mounting point
• If other fasteners appear worn or damaged, inspect and replace as needed

Rear leveling foot

This factory screw secures appliance panels and components, keeping them properly aligned and quiet during operation. Replace a stripped, corroded, or missing fastener to restore a snug fit and dependable performance in the original mounting location. What it does:

• Fastens brackets, panels, trim, or internal hardware to the cabinet/frame as specified by the manufacturer
• Helps maintain proper alignment and reduce rattling or vibration when a screw is worn or missing
• Direct replacement for damaged, stripped, or rusted hardware
• Used in various locations per the service diagram; match to the original position

• 1 screw

• Disconnect power (and shut off water or gas, if applicable) before servicing.
• Compare length and thread style to the original; install in the same location.
• Start threads by hand to avoid cross-threading; tighten until snug—do not overtighten.
• Reinstall any brackets or panels in the correct order.

This drain hose coupling connects two sections of the washer drain hose to restore a watertight path for wastewater, helping prevent leaks and restore proper draining. What it does:

• Joins two drain hose sections or connects hose to a mating outlet for secure water flow
• Seals the hose connection to reduce leaks at the joint
• Restores proper draining when a damaged or missing coupling causes slow drain or leakage
• Designed to fit the OEM hose profile for a snug, stable connection

• One drain hose coupling as shown

• Turn off power and water supply before starting any repair
• Inspect hose ends for damage; trim to clean cut if required for proper fit
• Push hose ends fully onto the coupling and secure with manufacturer-recommended clamps

Color: White. Size: 1 qt. can. Acrylic appliance paint.