Kenmore Washer 110.26922502 (11026922502, 110 26922502) Parts

Color: White. Size: 1 qt. can. Acrylic appliance paint.

Used on the pressure switch hose harness.

A small retainer clip that secures panels, hoses or wiring to keep components in place and reduce noise from loose parts. Replacing a worn or broken clip restores proper fit and helps prevent intermittent contact or rattling. What it does

• Secures trim, panels, hoses or wire harnesses to mounting points to prevent movement.
• Keeps components aligned so switches and seals engage correctly.
• Stops rattling or vibrating noises caused by loose parts.
• Helps prevent abrasion or chafing of wires and hoses by holding them away from edges.

• Install by snapping or sliding the clip into the factory mounting slot; use needle-nose pliers if needed.
• Power off and unplug the appliance before accessing internal parts.
• Inspect surrounding mounts and mating tabs for damage; replace if worn for a secure fit.
• If removal is difficult, apply a small amount of penetrating lubricant and work carefully to avoid breaking adjacent plastic.

Kit includes 2 sleeves.

Size: 10 - 24 x 3/8

Color: White.

Includes gasket sealer.

This cabinet top panel replaces the appliance's upper exterior surface to restore a flush fit and finished appearance. It protects internal components and helps maintain proper alignment of the control area and lid/door. What it does:

• Covers and protects the appliance cabinet's upper area from debris, spills, and wear
• Provides a mounting surface and alignment for the control assembly and lid/door
• Stops drafts, reduces rattling, and restores a uniform exterior fit and finish
• Addresses symptoms such as gaps at the top, loose or misaligned control area, or visible surface damage

• Disconnect power (and water supply for washers) before beginning any work.
• Removal/installation may require removing the control console or front/side trim; keep screws and small parts organized.
• Align tabs and screw holes carefully to avoid scratching the finish; hand-start fasteners before tightening.
• Inspect and replace sealing or trim pieces if damaged to ensure a proper fit.