Kenmore Washer 110.84870700 (11084870700, 110 84870700) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP388815
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: WP64137
$16.95
- Compare At:
-
$20.41
- You Save:
-
$3.46
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: 18849
$13.61
- Compare At:
-
$16.33
- You Save:
-
$2.72
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8529896
Installation instructions included.
Do-It-Yourself Stories from Customers like You
You could here the motor try to start but nthen just hum John H. • Brockton , MA • September 10, 2015
Found the motor switch was fried. So replaced that and the capacitor. Starts fine now.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W10831641
Washer tub ring that snaps onto the top of the outer tub. It acts as the tub cover and splash guard, guiding water back into the tub and supporting inlet or dispenser fittings to help keep the rim area contained.
- Attaches to the top of the outer tub as the upper splash guard/tub cover
- Directs water back into the tub; supports inlet/dispenser nozzles, if equipped
- Maintains proper clearance around the spin basket
- Common replacement signs: cracks, broken locking tabs, splashing from the rim, or rubbing at the top opening
What's included: 1 tub ring Install notes:
- Disconnect power and water supplies before servicing
- Lift or remove the top panel to access the tub rim
- Release locking tabs and detach any hoses/nozzles from the old ring; transfer fittings if needed
- Seat the new ring evenly; ensure all tabs fully engage. Reassemble and run a test cycle to check for leaks/splashing
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP359807
Do-It-Yourself Stories from Customers like You
The spin cycle on my washing machine was not working due to a faulty door/lid switch Joseph D. • Mechanicville , NY • February 17, 2015
I ordered a door/lid switch kit and an actuator and replaced them both. I probably didn't need the actuator, but it probably didn't hurt to replace it. The only issue I had was that the switch didn't seem to fit that well when installed on it's own, along with the actuator. So, I used the plastic shield which I had, along with the switch and actuator, as well as the old screws, as the screws that came with the kit were not long enough to accommodate the switch, actuator, and...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP64002
Do-It-Yourself Stories from Customers like You
Dryer drum was beginning to stall occasionally Dana J E. • San Marcos , CA • March 17, 2015
After shopping for a new Whirlpool Thin Twin Stack, Found appliance parts pros online and decided to take it apart to see if repair was a possibility. APPro's online instructions were easy to follow, in a couple hours it was apart, and I placed the order. Reg ground took a week from NY, so the laundry piled up that week. The parts arrived on Monday morrning, by afternoon the machine was running like new! The cause was the belt tensioner pulley had frozen. Replaced it, drum wheels,snap...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 285208
Use only in brake shoe assembly on roller & pin. Color: White/Grey.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 285549
Genuine Whirlpool part
By: Whirlpool
Part Number: 285777
Genuine Whirlpool part
By: Whirlpool
Part Number: 300450
Genuine Whirlpool part
By: Whirlpool
Part Number: 3347793
Genuine Whirlpool part
By: Whirlpool
Part Number: 63782
Genuine Whirlpool part
By: Whirlpool
Part Number: 711696
Genuine Whirlpool part
By: Whirlpool
Part Number: 98669
Do-It-Yourself Stories from Customers like You
The door switch failed when the door was opened the machine still ran Peter B. • Davie , FL • July 10, 2016
Replaced the switch...your videos are great! Five minutes and the job was done..OK,maybe ten,but with no swearing either!
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP19119
Do-It-Yourself Stories from Customers like You
Washer was "dead" with a partially washed load and would not do anything Jimmy M. • Hopewell , VA • September 19, 2014
Researched this kenmore washer on-line and found the problem to be the lid switch. Saw a diagram on how to jump this switch by connecting a wire to both outside wires on the harness and voila! It worked! This is not a fix but it allowed me to finish the load of unwashed clothes and told me which part was bad (do not run washer jumped like this.......fire hazard!)
Ordered the lid switch and it was an easy repair. A $14.00 switch was a lot cheaper than a $450.00 washer. Thanks appliance parts...
Read more
More