Kenmore Washer Dryer Combo 417.98862890 (41798862890, 417 98862890) Parts

Genuine Frigidaire part

Transmission

By: Frigidaire

Part Number: 134737100

This is a transmission assembly for washing machines. The transmission assembly is the gearbox in the washing machine's motor that allows the washing machine to work at different speeds and different intensities. If the washing machine is no longer spinning properly and has lost its normal level of washing power, it could mean that the transmission assembly needs to be replaced. Luckily, replacing this part is not as difficult as it might seem at first glance.To replace the transmission assembly, begin by unplugging the washing machine. The first step is to remove the upper control panel. Pull forward on the bottom of the console and remove the two retaining clips as well as the harness connector to the lid switch. Using a flathead screwdriver remove the clips. After this, remove the entire cabinet from the back panel to gain access to the interior of the washer. Remove the 7/16 bolt from the agitator and pull it straight up to remove it from the shaft. Once completed, gain access to the motor and pump and remove by releasing the screws and tabs that attach it. Remove the wire harness attached to the transmission. Remove the bolts that secure the motor mount to the transmission and proceed to pull the old transmission out of its place. Install the new transmission and reassemble the other parts.This genuine OEM replacement part is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, and Westinghouse washers. It is sold individually.

Do-It-Yourself Stories from Customers like You Deffective transmission bearing at the bottom Warren G. • Queens Village , NY • April 13, 2016

Replace with a new assy Read more

Genuine Frigidaire part

Cover Assembly

By: Frigidaire

Part Number: 131729301

This is a factory cover assembly that protects and finishes a specific component area on your appliance, helping keep internal parts shielded from debris and damage for reliable operation.

Shields internal components in the designated area from dust, splashes, and accidental contact
Helps maintain proper airflow/containment where designed
Can address issues like a missing, cracked, or loose cover causing rattles, exposure, or poor fit
Restores a clean, secure enclosure to the original design

What's included: One cover assembly, as pictured. Install notes:

Unplug the appliance and shut off any applicable utilities before servicing
Use appropriate hand tools; retain and reuse original fasteners
Handle edges carefully and align tabs/slots before tightening screws
Test operation and inspect for proper seating and clearance after installation

Genuine Frigidaire part

Bleach Dispenser

5.0 (1)

By: Frigidaire

Part Number: 3204394

Do-It-Yourself Stories from Customers like You Missing bleach dispenser. Jim W. • Ardmore , OK • May 12, 2020

Ordered part. Read more

Genuine Frigidaire part

Guide Clip

4.9 (9)

By: Frigidaire

Part Number: 5303281074

Do-It-Yourself Stories from Customers like You Nothing worked Roger D. • Lengby , MN • December 15, 2015

Replaced the fuse by the heating element Read more

Genuine Frigidaire part

End Cap

5.0 (1)

By: Frigidaire

Part Number: 131288211

White. Right hand side

Do-It-Yourself Stories from Customers like You Washer wouldn't run but as dryer did it obviously wasn't a circuit breaker E James W. • Wilmington , NC • September 29, 2014

First attempt was to replace the door latch mechanism...didn't fix it. Kept researching and the washer control knob had been hard to turn so it seemed logical that was the problem. Also, at some point the end cap had broken. As it has the main grounding point inside it and as I was taking the control panel apart anyway it made sense to replace it. Read more

Genuine Frigidaire part

Transmission Pulley

By: Frigidaire

Part Number: 131498301

Genuine Frigidaire part

Switch-Temp

By: Frigidaire

Part Number: 134192400

Genuine Frigidaire part

Insert

4.8 (5)

By: Frigidaire

Part Number: 5303212877

Vertical spring adjuster insert.

Do-It-Yourself Stories from Customers like You My washer started banging bad on the spin cycle and i would have to force the top open rearange the load and then it would work to finish after further review it was the springs David H. • Englewood , FL • April 06, 2018

Watched a few of your videos and ordered the springs and a insert, and actually got the parts right. I am not a Appliance repair guy but I am retired and I am pretty handy so I thought what the heck. I watched the videos, a lot of common sense, common tools, and plenty of time. My knuckles are busted up and a little blood, but I got it done. Was actually kind of rewarding. Works like a champ. The Videos, ARE AWESOME. Read more

Genuine Frigidaire part

Lid Lock Switch Assembly

4.9 (22)

By: Frigidaire

Part Number: 134101800

This washer switch is both the lid lock and lid switch. New mounting bracket replaces older design. Which means in some applications you may need to drill off old design mounting bracket prior to mounting the new lock. If your replacing the 4 wire switch you will need to tape off light switch leads. The light will no longer be used. Instructions included.

Do-It-Yourself Stories from Customers like You My 20 year old frigidaire stackable washer needed the lid switch replaced so it would trigger the spin cycle Maryann S. • Owosso , MI • March 13, 2014

I unplugged the power source to the appliance. I unscrewed 2 screws and unplugged the lid switch. I replaced the old switch with the new switch and screwed in the same 2 screws that held the old switch in place and plugged the new lid switch back in under the lid. that's it . I plugged in the washer and started a load of clothes. works just fine. NO HUGE REPAIR BILL. Gosh it makes me happy to do such a simple repair to my old machine and for a very reasonable part price, my washer is... Read more