Kenmore Dishwasher 665.16264402 (66516264402, 665 16264402) Parts

Color: Biscuit. Screw for lower toe panel. For black screw use WP302868, for white screw use WP3400836.

Color: White. Size: 1 qt. can. Acrylic appliance paint.

Color: White

This replacement capacitor shield protects the appliance's capacitor from debris, contact and shorting, helping extend component life and reduce electrical faults. It installs over the capacitor to block dust, wiring contact and accidental damage. What it does:

• Covers and protects the capacitor from physical contact, dust and loose wiring
• Helps prevent short circuits and arcing caused by accidental contact with the capacitor
• Useful when existing shield is cracked, missing or deformed
• Can reduce risk of intermittent electrical faults related to exposed capacitor

• One capacitor shield (protective cover)

• Always disconnect power to the appliance before servicing
• Capacitors can hold a charge; discharge safely before touching electrical components
• Remove necessary access panels to reach the capacitor; replace shield without stressing wires

This clip is a small retainer used to secure panels, wiring, or hoses so components stay in place and operate quietly. It prevents loose parts from shifting during normal use and helps maintain appliance fit and finish. What it does:

• Holds wiring, harnesses, or small hoses in position to prevent rubbing or disconnection
• Keeps trim or access panels seated to reduce vibration and noise
• Helps maintain correct routing to avoid wear on wires and hoses
• Commonly replaced when the original clip is broken, cracked, or missing

• One clip

• Disconnect power to the appliance before attempting any repair
• Access the area and remove any panels or covers that block the clip location
• Press the clip into its mounting slot or snap the harness into the clip until it seats securely
• Replace any damaged surrounding fasteners or retainers; do not use damaged clips

The Whirlpool push on retainer nut is an OEM replacement part responsible for securing the heating element in the dishwasher. It is located in the base of the dishwasher's tub to hold the heating element firmly in place. The push-on retainer nut keeps the heating element securely connected to the dishwasher's electrical system while allowing for easy removal and replacement when necessary.

Over time, push on retainer nuts can become loose, worn out, or damaged due to regular use, vibrations, or accidental mishandling. If a retainer nut fails, it can lead to parts becoming unstable or disconnected.

Symptoms of a bad push on retainer nut include:

• Loose or unstable dishwasher components
• Parts falling off or becoming misaligned
• Unusual noises during the wash cycle
• Difficulty in securing components within the dishwasher

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models

The Dishwasher Drain Pump is an OEM part for Whirlpool dishwashers. It is responsible for removing water from the dishwasher at the end of each cycle, ensuring that dishes are properly cleaned and dried.

Causes of a bad drain pump can include wear and tear from regular use, blockages from debris, or electrical malfunctions.  

Symptoms of a bad drain pump include:

• Water not draining from the dishwasher
• Unusual noises during the drain cycle
• Error codes related to drainage issues
• Water pooling at the bottom of the dishwasher

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.